V6 User Manual 1.00.book - Studio General

GPI / GPO SupportGPI/O support is available as a Remote Controller module.Note: For the present the only supported GPI/O interfaces are the following modelsmanufactured by Sealevel:• SeaPORT PLC-16 8 in 8 out• SeaI/O-410U 16 in 16 out• SeaI/O-420U* 16 in 8 out• SeaI/O-430U* 32 in 0 out• SeaI/O-440U* 0 in 32 out• SeaI/O-450U* 0 in 16 out* Obtainable on special orderNote: Note: USB drivers are included in the Pyramix Installer, there are no need to downloadthe driver from the supplier website. For more information about the specificationof the GPIO hardware device please see:Using the GPI/O controllerAdd a GPI/O Controllerhttp://www.sealevel.comBefore Pyramix can use the adaptor, it must be set up.Select the Settings > All Settings > Remote Control > Controller pageClick the Add button. The Controller Properties dialog opens. Type a name for the Controller and select GPI/GPOfrom the Driver drop down list. Click OK to close the dialog and click OK to close the Pyramix Settings window.Note: Do not do this more than once. Only one GPI/GPO controller is allowed. Howeverthis can control more than one physical GPI/GPO USB ModuleGPIO Controller Properties dialogEnable/DisableThe GPI/GPO controller may be disabled by unchecking the Enable box in the Controller Properties Dialog.Some GPI/GPO USB Modules can be individually enabled or disabled by clicking on the Properties button to theright of the Driver combo box.Configuring the GPI/O controller for a specific projectOpen the Settings > All Settings > Project > Controller Mapping page.Select your GPI/O controller and click Properties. The GPI/O Controller Configuration Window will appear; On theleft you can browse the Remotes list. Next to this is the GPI/O Controllers list. To map a Remote to a GPI/O Input orGPI / GPO Control : GPI / GPO Support 23 - 397