V6 User Manual 1.00.book - Studio General

Note: At bottom left in the screenshot above the button labelled Buses indicates whichsources are available for activation. Clicking on this button toggles through Buses,Externals and Buses / ExternalsMain, centre section:Selected Sources>: Select previous/next Pyramix source. Only sources visible in the Sources section are available. I.e.If the component channels of a bus or stem are collapsed this bus or stem is switched as a unit when the componentchannels are visible in the Sources section then clicking on the > buttons steps through each availablechannel in turn.>: Select previous/next External Source. Only External Sources visible in the Sources section areavailable.Note: Clicking on any of the > buttons cancels the selection made previously inthe Sources section.Selected Output>: Select previous/next Speaker Set.>: Select the previous/next Downmix defined in the Configure page.Main areaSpeakers are inactive (grayed) if they are not connected in the Configure page.The Mode buttons at the bottom determine the function of the active Speaker buttons.Mute: Clicking on a speaker mutes it. Selections are cumulative.Solo: Clicking on a speaker solos it. Selections are cumulative.SoloX: Solo eXclusive on the clicked speaker. Selections toggle.Phase: Clicking on a speaker reverses its phase. Selections are cumulative. Useful for quick imaging checks.In Place Works in conjunction with Solo and SoloX. Toggles between In Place and Center.Reset: Deselect all speakers.In Place/Center: In Solo and SoloX, toggles between In Place and Center. Center routes the soloed channel(s) tothe Center speaker or equally to the L/R speakers if no center speaker is present. In Place mode is the normal Solo,SoloX mode.Output, right-hand areaMonitor Level box Displays the current output level. Output level can be entered numerically in the box afterclicking on it.Volume Knob: sets all the output gains in a range from -144.5dB to +24dB. Double-click to set it to 0dB.Note: Maximum permissible volume can be set in the Configure page.Mute: button mute the outputs.Dim: button reduces the output level by an amount set in the Configure page. Default value is -20dB.Below these buttons is thePeak Meter Selection: Indicator/Button. This indicates what the Peak Meter display below the button is lookingat. (The selection also affects External Metering if you are using it) Clicking on the button drops down a list ofMonitor : Monitor ! page 11 - 198