V6 User Manual 1.00.book - Studio General

Audition before Start of Fade In from the Reference PointAudition Fade In before its StartThe Graphical DisplayConsists of the following elements:• The TimeCode scale displaying the Zoom range on its left.• A Reference Point which is set by default at the edit point or in the middle of the (X) Fade. This marker canbe moved by clicking in the TimeCode Scale and is just a Reference Point for Auditioning (see above) or forAuto-Center (see below)• All tracks or a selection can be displayed (see Parameters & Options below)• At the left of each track display The Track name of each clip is shown, with a toggling Edit On/Off selector.This allows one or more Clip’s/Fades to be excluded from further modification.• A Vertical Scrollbar navigates through hidden tracks if any• An Horizontal Scrollbar navigates before and after the Fade position• The outgoing and incoming clip fades are displayed with curves• The Fade Position can be moved by clicking and dragging within the Fade area (Cursor changes tohand)• The Fade Length can be changed by clicking and dragging on the left or right side of the Fade area.(cursor changes to )• The Media of the clips can be moved by clicking and dragging outside the Fade area. (Cursorchanges to hand with tape reel)• The Fade Curves can be modified by clicking and dragging on the Bezier Control Point Handles in the Fade blackboxWaveform Color ChangeThe waveform color can be used to indicate where the main Playhead Cursor is in relation to the Reference Point.When the Update waveform color with cursor position checkbox is ticked in Settings > All Settings > Application> Editing : Fade Editor the waveform(s) color will change to the color chosen in Settings > All Settings >Application > TimeLine Layout : Clips & Waveforms - FadeEditor Waveform Position Color according to thelocation of the main Playhead Cursor and the Reference Point (default is centre of crossfade)Context MenuRight-clicking in the graphical display pops-up a context menu:The Fade In, Fade Out and X Fade sub-menus offer choices of Default (complete or Curve Only), Standard, (anyof the standard fade curves) and Load (from the list of previously saved presets)The Faders & Control SectionHas the following controls and displays:• The Fade Safe check box in the Fader section ensures (when checked) that all following fades to the rightof the one being edited are left intact while editing the current fade. This enables Auto-Ripple to be usedwithout Auto-Ripple while keeping Fade synchronization clean.Fade Editor : The Graphical Display 9 - 139