V6 User Manual 1.00.book - Studio General

ADAT Board SettingsNote: These settings can only be changed when all projects are closed. The page willwarn of this if any projects are open.I/O InterfaceInputOffers the choice between ADAT and SPDIFOutputOffers choices of output format:All Settings Hardware I/O Interfaces ADAT Board(#Serial No.)ADAT 1-8 / ADAT 9/16: Channels 1-8 on optical A and channels 9-16 on optical B.ADAT 1-8 / ADAT 1-8: Channels 1-8 on both optical A and B.SPDIF 1-2 / ADAT 1-8: (Standalone mode only) Channels 1-2 on optical A, in SPDIF format and channels 1-8 on opticalB.SPDIF 1-2 / ADAT 9-16: (Standalone mode only) Channels 1-2 on optical A, in SPDIF format and channels 9-16 onoptical BOptical OutputCheck the Optical output level box if the fibre-optic cables are in excess of 10[m] / 30 [feet] in length.SPDIF/ADIANA Output FormatThe radio buttons set the Professional / Consumer flag and the check-box sets the Copy Inhibit flag when SPDIFis the selected output format.Settings : I/O Interfaces 27 - 490