V6 User Manual 1.00.book - Studio General

NotesLeft Mouse ButtonDrag the notes (to a library)Shift + AltMedia FolderLeft Mouse ButtonReplace media for target clip(s)CtrlAppendix II I/O Daughter-card OptionsADAT Optical I/OThe ADAT Optical daughter card offers 16 channels of audio input and 16 channels of audio output, 8 channels peroptical connection. From top to bottom of the card, it has two digital optical input connectors (Inputs A and B) andtwo digital optical output connectors (Outputs A and B).The signal format of optical connectors Input A and Output A can be set inside the Pyramix software to operate ineither ADAT or S/PDIF mode. When in ADAT mode, there are 8 discrete audio channels carried per each opticalconnector. S/PDIF mode has 2 channels per optical connector.Note: in SPDIF mode the maximum sampling rate is limited to 48 kHzNote that whilst the ADAT daughterboard continues to function normally in HDTDM (64 bus) mode it cannot beused for input when in XDTDM (128 bus) mode and is only capable of 8 outputs via Optical Output A with thesame 8 duplicated on Optical Output B.WARNING! The ADAT Daughterboard requires modification before attempting to use it with XDTDM mode. Failureto do this may result in data loss. Please contact your Merging Technologies Sales Partner to arrange a mod.AES/EBU I/OThe AES/EBU daughter card offers 24 channels of I/O over 12 AES/EBU input and output pairs. Connection is viathree DB-25 connectors, One on the main card attached to the Mykerinos and two more on a separate bracketconnected via internal ribbon cable to the main card. An optional break-out cable can be ordered separatelywhich connects to the DB-25 connector and terminates in 8 XLR connectors which may be used to connect tostandard AES/EBU stereo inputs and outputs. AES daughter cards are available with or without 8 channels of SRC(sample rate conversion)AES II with SRCThe AES II daughter card is equipped with 4 unidirectional SRC chips. Each one can be configured as bypass, inputor output. On a specific in/out channel pair a sampling rate conversion can be applied only in one direction, eitherinput or output. The "Speed on physical wire" setting should be set to the project's sampling rate (aka "single-wiremode") whenever the SRCs are used, since channel pairs that are spread over several wires will not be sample rateAppendices : Appendix II I/O Daughter-card Options 29 - 562