V6 User Manual 1.00.book - Studio General

Dynamic Automation ModesEvery control in the mixer can be set to one of four dynamic automation modes. The automation mode can be setfor individual controls, for channel strips, for buses, for groups of controls or for the whole mixer. The current modeis shown by the absence, presence and color of small indicators.Auto-Write Write Read IsolateDynamic Automation Mode IndicatorsAuto-WriteNo indicator.(This is the default for all controls)With the transport in Play, and the Master Automation Controls in Play or Write modes, the control(s) Read(play back) previously recorded automation data.In Write mode When a control is moved new automation data is written until the control is released. Behaviorwhen the control is released, or the transport stopped, is governed by the choices made in the Automation menuand in Automation > Automation Settings.WriteRed triangle indicator.With the transport in Play, and the Master Automation Controls in Write mode, the current state of all controls inRecord mode is recorded as automation data.ReadGreen triangle indicator.The control(s) follow the last automation data recorded for them or maintain their default position where no previouslyrecorded automation data exists.IsolateBlack triangle indicator.The control(s) are isolated from any automation moves already recorded. Controls can be moved without affectingexisting automation data.Selecting Automation ModesDefault ModeThe defaullts mode is Auto-Write. Move a control and automation data is written automatically. Press a buttonand the same applies.Automation : Dynamic Automation Modes 14 - 264