V6 User Manual 1.00.book - Studio General

Sampling Rate ConvertersGrayed out if no SRCs are present. Each of the four uni-directional converters can be configured as Bypass, Input orOutput. On a specific in/out channel pair a sampling rate conversion can be applied only in one direction, eitherinput or output. The Speed on physical wire setting (see below) should be set to the project's sampling rate (aka"single-wire mode") whenever the SRCs are used, since channel pairs that are spread over several wires will notbe sample rate converted properly.Up to 192 kHz, each column represents one XLR connector (one pair of channels) with its associated SRC chip.The following configurations can be selected:• None: or bypass, the SRC is transparent• Input: The SRC works on the input path and converts the incoming signal to the project's sampling rate• Ref1/2 through Ref 7/8: The SRC is inserted in the output path and converts the output signal to the samplingrate of the signal present at the input chosen as reference.At 8FS (DXD/DSD), the AES II daughter card has a special mode that is enabled by selecting 8FS to nFS in theSpeed on physical wire field. This mode provides a fixed set of 2 input and 2 output paths and enables a real-timeconversion from 384kHz/352.8kHz down to 192kHz/44.1kHz and vice-versa. Only XLRs 1/2 and 3/4 are used. Forthe outputs, the reference input for the sampling frequency is selectable in the Sampling Rate Converters array.For further information and configuration examples please see: AES II with SRC on page 562High Sampling Frequency (24 Inputs / 24 OutputsSpeed on physical wire (when possible)Sets the rate of the AES stream on the I/Os.44.1k / 48k: standard mode88.2k / 96k: also called single wire at 96 kHz176.4k / 192k: (only AES 2) also called single wire at 192 kHz8 FS to nFS: (only AES 2 - SRC) special mode for the sampling rate converters for DXD/DSD projects (see explanationof the sampling rate converters)DSD mapping (DSD / DXD Projects only)Sets the mapping for the DSD I/OsInputSONYP3DOutputSONYP3DI/O Audio Format (DSD / DXD Projects only)Selects the I/O mode when a DSD or DXD project is opened.InputDSDDXDOutputDSDDXDSettings : I/O Interfaces 27 - 492