z/VM: System Messages and Codes Š CP - z/VM - IBM

user ID that is in the directory or contact your system
administrator to obtain the necessary authorization.
HCP008E Invalid spoolid - spoolid
Explanation: The spool ID specified is not a valid
decimal number, is larger than four digits, or is 0.
System Action: The command is not executed;
system operation continues.
User Response: Reissue the command with a valid
spool ID number.
HCP009E The variations of this message are
explained below.
MESSAGES:
v Invalid range - range
v An invalid address range was specified.
Explanation: You did not specify the range of
addresses or registers correctly. For example, you may
have specified the ending address as less than the
starting address, or you may have specified too many
ranges.
System Action: CP does not execute the command;
system operation continues.
User Response: Issue the command again and
specify a valid range.
HCP010E The variations of this message are
explained below.
MESSAGES:
v Invalid register - register
Explanation: The register you specified is:
– Outside the range of 0 through 15
– Outside the hexadecimal range of 0 through F
– Not a 0, 2, 4, or 6 for a floating-point register. (If
floating-point extensions are installed, you can
have 0-15 floating-point registers.)
v Invalid register - not specified.
Explanation: The register prefix value was specified
(for example, G), but a register number was not
specified.
System Action: The command is not executed.
System operation continues.
User Response: Reissue the command. Specify a
valid register.
HCP011E Invalid device type - userid vdev
Explanation: The device type is invalid.
If this is the COUPLE command, the device that was
specified is not a virtual channel-to-channel adapter.
If this is a DIAL command, the device specified is not a
virtual line.
System Action: The command is not executed;
system operation continues.
User Response: Make sure that the device is the
correct type for the function and reissue the command.
HCP012E Invalid PSW - psw
Explanation: The program status word (PSW)
specified by the STORE command is invalid. For
instance, a valid PSW for an XA virtual machine is
defined by the architecture to have certain bits off.
System Action: System continues operation.
User Response: Change the PSW to a valid format
for the mode of the virtual machine. If you do not do
this, attempting to run the virtual machine with an invalid
PSW causes the CP dispatcher to issue an invalid PSW
message.
HCP013E Conflicting option - option
HCP008E HCP016E
Explanation: The function required by the given option
is incompatible with a previously specified option. This
may occur if the same option is specified twice in the
same command.
This message is issued if the DCSS parameter is
specified on the VMDUMP command for an address
space that does not have a saved system associated
with it.
System Action: The command is not executed;
system operation continues.
User Response: Reissue the command with valid
options.
HCP015E Command not valid before LOGON:
command
Explanation: A user has attempted to issue either the
DIAL or MESSAGE command. During system
installation the customer can flag these commands so
that they cannot be issued prior to logging on the
system. The command was the CP command that was
issued by the user.
System Action: System operation continues.
User Response: If the MESSAGE command was
issued, the user should logon the system and then
reissue the command. There is no alternative action a
user can take for the DIAL command.
HCP016E TAG invalid for specified file type
Explanation: The spool file cannot be tagged. The
splink (the data buffer) does not leave space for tag
information (accounting, dump, and monitor files).
Chapter 3. System Messages 139