z/VM: System Messages and Codes Š CP - z/VM - IBM

usable; system operation continues.
User Response: Issue the RESTART MSGP CP
Command to reload the CF Service Machine. If this
message is encountered repeatedly, contact your
system administrator or the IBM Support Center for
assistance.
Operator Response: Issue the RESTART MSGP CP
command to reload the CF Service Machine. Or, log off
the CF Service Machine with the CP FORCE command;
then issue the XAUTOLOG command to restart the CF
Service Machine. If this message is encountered
repeatedly, contact your system administrator or the
IBM Support Center for assistance.
Programmer Response: None.
HCP2815E The variations of this message are
explained below.
MESSAGES:
v The virtual storage size of the CF Service
Machine must be greater than nnnnM to load the
message processor.
Explanation: A virtual storage size defined for the CF
Service Machine is not sufficient to load the Coupling
Facility Control Code (CFCC) Licensed Internal Code
from the processor controller.
System Action: The CF Service Machine is not
usable; system operation continues.
User Response: Contact your system administrator
for assistance.
Operator Response: Contact your system
administrator for assistance.
Programmer Response: Increase the storage size
and issue the command again.
v The virtual storage size must be greater than
nnnnM to perform a Guest IPL from a SCSI
device.
System Action: The IPL request is terminated. The
current user’s virtual machine is reset.
User Response: Re-IPL from some other type of
disk. Increase the virtual storage to at least the
minimum amount indicated and reissue the
command.
Operator Response: None.
Programmer Response: None.
HCP2816I The variations of this message are
explained below.
MESSAGES:
v Loading message processor msgprocid from the
processor controller.
Explanation: z/VM is currently loading the Coupling
Facility Control Code (CFCC) Licensed Internal Code
from the processor controller into the CF Service
Machine’s virtual storage. On completion of the load,
z/VM will automatically start the message processor.
v Acquiring the machine loader from the processor
controller.
Explanation: z/VM is currently loading the Guest IPL
machine loader from the processor controller into the
current user’s virtual storage. Upon completion of the
load, the machine loader will access the specified
FCP-attached SCSI disk to complete the IPL request.
System Action: System operation continues.
User Response: None.
Operator Response: None.
Programmer Response: None.
HCP2817I The variations of this message are
explained below.
MESSAGES:
v Load completed from the processor controller.
Now starting message processor msgprocid.
Explanation: z/VM has completed the loading of the
Coupling Facility Control Code (CFCC) Licensed
Internal Code from the processor controller into the
CF Service Machine’s virtual storage. The specified
message processor will be started. Verify that the
message processor has been started by examining
the messages on the CF Service Machine’s console.
v Load Completed from the processor controller.
Now starting the machine loader.
Explanation: z/VM has completed the loading of the
Guest IPL machine loader from the processor
controller into the current user’s virtual storage. The
machine loader will now access the specified
FCP-attached SCSI disk to complete the IPL.
System Action: System operation continues.
User Response: None.
Operator Response: None.
Programmer Response: None.
HCP2818E The request to load the {msgprocid |
machine loader} from the processor
controller has been cancelled.
Explanation: An active request to load either a CF
Service Machine or the machine loader from the
processor controller has been terminated by z/VM. In
the case of a CF Service Machine, this message is
issued when z/VM cancelled a load for the following
reasons:
1. msgprocid is logged off.
HCP2815E HCP2818E
2. msgprocid performs a virtual system reset.
3. A user issues a RESTART MSGPROC to a CF
Service Machine user ID that is currently loading a
file.
Chapter 3. System Messages 313