z/VM: System Messages and Codes Š CP - z/VM - IBM

HCQ034E xxxxxxxx yyyy not found
Explanation: The indicated item has been requested
in the subcommand and could not be located in the
dump. Possibilities include:
v Real device nnnn
v Subchannel nnnn
v Virtual device nnnn
v Active radix tree elements
v Device nnnn (could be real or virtual)
System Action: The subcommand or macro
terminates.
User Response: Enter the subcommand again using
an element number that can be found in the dump.
HCQ035E code not found in file fn ft
Explanation: The indicated abend code could not be
found in the indicated file.
System Action: The subcommand or macro
terminates.
User Response: If this is a user-defined abend code,
you may add it to the file indicated to display the
meaning of the abend code and avoid this message. If
this is a CP-generated abend code, report the problem
to the IBM Support Center.
HCQ036E Increment must be positive - incr
Explanation: An increment must be positive, and a
zero or negative value was found.
System Action: The subcommand or macro
terminates.
User Response: Enter the subcommand or macro
again using a positive increment value.
HCQ037W Too many processors in dump
Explanation: The number of processors found in the
dump exceeds the number of processors that the VM
Dump Tool is set up to support (32).
System Action: Processing continues. Only data from
the supported number of processors are included in the
trace information.
User Response: Be aware that some trace data will
be missing. If the dump was created by running in a
virtual machine, run with fewer virtual processors next
time. If this dump was taken on supported hardware,
report the problem to the IBM Support Center.
HCQ038E Output plus output length exceeds
right margin xxxxxxxx offset set to zero
Explanation: The output being produced by the
subcommand or macro has been indented too far to fit
on a line. The first 8 characters of the text is displayed.
System Action: The subcommand or macro
terminates.
User Response: Use a smaller INDENT value and
enter the subcommand or macro again.
HCQ040E Not a valid decimal number - xxxxxxxx
Explanation: The indicated value is required to be a
decimal number, and was not.
System Action: The subcommand or macro
terminates.
User Response: Enter the subcommand or macro
again using a decimal number.
HCQ041W control_block could not be found, some
subcommands may fail
Explanation: This is a warning when the partial dump
is entered that SYSCM (SYStem CoMmon), the Frame
Table, or some other CP control block could not be
located.
System Action: Processing continues.
User Response: Be aware that some subcommands
or macros may produce messages or errors because
the given control block was not found.
HCQ042E Error nnn setting variable
HCQ034E HCQ043E
Explanation: CMS returned an error when a REXX
variable was being set.
System Action: The subcommand or macro
terminates.
User Response: Consult the explanation of the
indicated error in the z/VM: System Messages and
Codes - CMS and REXX/VM book to determine if you
have made an error. Enter the subcommand or macro
again with the correct parameters.
HCQ043E Must be issued from a macro
Explanation: This subcommand can be issued only
from within a macro.
System Action: The subcommand terminates.
User Response: See if there is an alternate
subcommand or macro that can supply the required
information. If none is found, then write a small macro
to issue the required subcommand.
Chapter 3. System Messages 475