z/VM: System Messages and Codes Š CP - z/VM - IBM

dynamic I/O capability was either enabled or disabled
on the system at IPL time.
System Action: None.
User Response: None.
HCP6858I RDEV rdev has been deleted
Explanation: A user entered the DELETE DEVICE
command, and as a result, the RDEV or RDEVs
associated with the specified devices were deleted.
System Action: None.
User Response: None.
HCP6859E RDEV rdev cannot be changed or
deleted because it is a static device
definition from HCPRIO
Explanation: RDEV rdev represents a device that was
statically defined in the HCPRIO ASSEMBLE file, but
this definition is not eligible to be changed or deleted.
System Action: RDEV rdev remains unchanged.
User Response: None.
Operator Response: None.
Programmer Response: Change or delete the
RDEVICE macro specification in HCPRIO and rebuild
the system. If changes are needed prior to rebuilding
the system, redefine the device dynamically to a device
number that is not in HCPRIO.
HCP6860E Device rdev cannot be attached to the
system because it is an alias Parallel
Access Volume.
Explanation: The indicated device, which was
specified on the ATTACH command, could not be
attached to the system because alias Parallel Access
Volumes are not supported as system-owned devices.
System Action: The device is not attached to the
system; system operation continues.
User Response: Reissue the ATTACH command with
a valid device number.
HCP6861I Device rdev cannot be varied online
because it is an alias Parallel Access
Volume for which the base could not
be located.
Explanation: The indicated device could not be
brought online because all alias Parallel Access Volume
devices must have an associated base device, and the
base for this alias could not be located.
System Action: The device is not brought online;
system operation continues.
User Response: None.
HCP6858I HCP6864E
Operator Response: Examine the I/O configuration to
verify that this device is an alias Parallel Access Volume
and that it has an associated base volume. Verify that
the base volume exists and is online. For further
assistance, contact your system support personnel.
HCP6862E Device rdev cannot be changed or
deleted because it is a base Parallel
Access Volume for which an alias
exists.
Explanation: The indicated device, which was
specified on the SET RDEVICE or DELETE RDEVICE
command, could not be changed or deleted because it
is a base Parallel Access Volume with one or more alias
volumes still associated with it.
System Action: The device is not changed or deleted;
system operation continues.
User Response: Issue the QUERY PAV command to
see what alias Parallel Access Volumes exist for the
specified device. Before you can change or delete the
base volume, you must delete all the alias volumes
associated with it.
HCP6863E Device rdev has not been attached
because it is an alias Parallel Access
Volume for which the base is in use by
the system.
Explanation: The indicated alias device was not
attached because its associated base device is
currently attached to the system.
System Action: The device is not attached; system
operation continues.
User Response: Detach the base volume from the
system and reissue the ATTACH command for the alias
volume.
HCP6864E Device rdev has not been attached
because it is a base Parallel Access
Volume for which one or more alias
volumes are dedicated to a guest.
Explanation: The indicated base device was not
attached because associated alias devices are currently
attached to one or more guests. A base Parallel Access
Volume cannot be attached to the system at the same
time that any of its alias volumes are attached to
guests.
System Action: The device is not attached; system
operation continues.
User Response: Detach the associated alias volumes
and reissue the ATTACH command for the base
volume.
Chapter 3. System Messages 415