z/VM: System Messages and Codes Š CP - z/VM - IBM

HCP9310E HCP9904I
HCP9310E No soft abend dump files exist.
Explanation: Soft abend processing tried to access a
previously allocated soft abend dump file, and the file
did not exist.
System Action: The soft abend information collected
is not written to a system data file. The system
continues normal operation.
User Response: Contact your system support
personnel.
HCP9311I The SNAP data parameter list is full.
Some data will not be included in the
dump for soft abend code.
Explanation: This message informs the system
operator there is no more room in the snap data
parameter list to save the data specified by the failing
module. The code is a CP soft abend code.
System Action: Only those data items that were
stored in the snap data parameter list will be in the soft
abend dump.
Operator Response: No action is required.
HCP9423I Insufficient storage to allocate an
SCMBK. Subchannel measurement will
not be enabled for device XXXX
Explanation: CP ran out of storage allocated for
subchannel measurement blocks. Subchannel
measurement is not enabled for the device.
System Action: System operation continues.
Operator Response: Increase the amount of storage
that CP allocates for subchannel measurement blocks
by adding/updating a STORAGE SCMBK statement in
your system configuration file.
HCP9500E Invalid substitutions in the following
messages from module name
Explanation: CP attempted to write a message to the
console. The message is more than 8 characters long,
which is the length limit for a system message. The
module name variable refers to the module issuing the
message.
System Action: The erroneous message is typed
without substitution, and system operation continues.
User Response: Notify the system programmer.
HCP9501E MSG*PAGING ERROR: CALLER:
mmmmmm+nnnn DATA =
substitution-data
Explanation: A paging error has occurred that
prevented the proper format presentation of an error
message. The variables are as follows:
468 z/VM: System Messages and Codes — CP
mmmmmm
The module issuing the message
nnnn The offset within the module, where the error
message was issued.
System Action: System operation continues.
Operator Response: If the failure persists, notify
system support personnel.
Programmer Response: If the problem persists,
contact your IBM Support Center personnel to diagnose
and correct the software problem.
HCP9901I LKFAC configuration config_name
Created
Explanation: When SET LKFAC is specified with a
configuration name, it connects a user to a Multi-Path
Lock Facility (MPLF) RPQ simulation configuration. This
message is issued if the configuration name was not
previously defined in the configuration name table.
System Action: The configuration name table is
updated appropriately. Processing continues.
User Response: None.
HCP9902I userid Added to LKFAC configuration
config_name
Explanation: When SET LKFAC is specified with a
configuration name it connects a user to a Multi-Path
Lock Facility (MPLF) RPQ simulation configuration. This
message is issued if the configuration name is already
defined in the configuration name table.
System Action: Processing continues.
User Response: None.
HCP9903I userid Removed from LKFAC
configuration config_name
Explanation: When SET LKFAC is issued without a
configuration name it disconnects a user from a
Multi-Path Lock Facility (MPLF) RPQ simulation
configuration.
System Action: The user is removed from the named
MPLF simulation configuration.
User Response: None.
HCP9904I LKFAC configuration config_name
Deleted
Explanation: When SET LKFAC is issued without a
configuration name it disconnects a user from a
Multi-Path Lock Facility (MPLF) RPQ simulation
configuration. This message is issued if the user is the
last user connected to the configuration. In this case the
configuration is deleted.
System Action: The configuration name table is