z/VM: System Messages and Codes Š CP - z/VM - IBM

HCP1772E HCP1779I
HCP1772E MORE THAN ONE PROFILE NAME
WAS SPECIFIED ON THE type
STATEMENT FOLLOWING USER userid.
Explanation: The INCLUDE or POOL statement
following USER userid has more than one name
specified on it.
System Action: The card image is displayed above
the error message. The program is terminates after
scanning the remaining statements for syntax.
User Response: Correct the INCLUDE or POOL
statement, specifying only one PROFILE, and reenter
the DIRECTXA command.
HCP1773E A PROFILE STATEMENT WAS FOUND
PRECEDING THE DIRECTORY
STATEMENT.
Explanation: A PROFILE statement was found
preceding the DIRECTORY statement.
System Action: The card image is displayed above
the error message. The program terminates after
scanning the remaining statements for syntax.
User Response: If the PROFILE statement was
extraneous, delete it or move it to its appropriate
position and reenter the DIRECTXA command.
HCP1774E THE RPWLIST ENTRY - rpw - IS
INVALID.
Explanation: The RPWLIST entry in the message is
invalid for one of the following reasons:
v The password entry did not start in column 1.
v The password was not a contiguous set of 1 to 8
nonblank characters.
v Column 9 was not blank.
System Action: The card image is displayed above
the error message. The program terminates after the
remaining statements are scanned for syntax.
User Response: Correct or delete the invalid entries
and reenter the DIRECTXA command.
HCP1775E PROFILE DEFINITION profname IS
INVALID AND WILL NOT BE
PROCESSED FOR ANY USER
DEFINITIONS THAT INCLUDE IT.
Explanation: Control statements in the named
PROFILE definition were found to be in error. The
PROFILE is marked as invalid.
System Action: The PROFILE name will be validated
for all INCLUDE statements that reference it, but the
content will not be processed for any USER definitions
that include it. The program terminates after the
remaining statements are scanned for syntax.
User Response: Correct the control statements of the
250 z/VM: System Messages and Codes — CP
named PROFILE that were in error and reenter the
DIRECTXA command.
HCP1776E DEFAULT STORAGE SIZE EXCEEDS
MAXIMUM STORAGE SIZE FOR USER
userid
Explanation: After resolving which default and
maximum storage sizes to use from the USER
statement, the user, and the profile STORAGE and
MAXSTORAGE statements, the default size exceeded
the maximum.
System Action: The directory program terminates
after scanning the remaining statements for syntax.
User Response: Correct the storage specification and
rerun the DIRECTXA program.
HCP1777E The directory on volume volser could
not be initialized
Explanation: A CP-owned volume with directory space
that CP attempted to bring online during initialization
was not valid.
System Action: The system continues searching
CP-owned volumes for a valid directory.
Programmer Response: If the directory specified in
the message is not the directory you want brought
online, no action is necessary.
If the directory specified in the message is the directory
you want brought online, you must rewrite the directory,
using the DIRECTXA CMS command.
HCP1779I THE DEVICE TYPE type ON THE
PRECEDING CONSOLE STATEMENT IS
INVALID AND SHOULD BE CHANGED
TO THE APPROPRIATE VALUE. IT HAS
BEEN DEFAULTED TO 3215 FOR THIS
EXECUTION OF DIRECTXA.
Explanation: As of VM/XA SP
Release 1 there was
no support for the device types 1052 and 3210. While
DIRECTXA is operating in MIXED mode, the values are
accepted and defaulted to the equivalent of 3215.
System Action: Display the failing CONSOLE
statement, display this message, default the device type
to 3215, and continue processing.
User Response: Check the z/VM: CP Planning and
Administration description of the CONSOLE statement
for the correct device type value, enter it on the
CONSOLE statement, and reenter the DIRECTXA
command.