z/VM: System Messages and Codes Š CP - z/VM - IBM

HCP1159E HCP1251I
User Response: If all of the systems in the CSE
complex for this disk are at VM/ESA Version 1 Release
1.1 or greater, the disk can be xlink formatted from one
of these systems and the enhanced link modes will be
valid.
HCP1159E DASD address is not linked; RDEV rdev
is already attached.
Explanation: The DASD the user is trying to link to is
already attached to another user.
System Action: System operation continues.
User Response: Ensure that the specified RDEV is
not already attached to another user, then reenter the
command.
HCP1160E Device vdev has excessive indirect
links in CP directory
Explanation: The device vdev is defined in the
queried user’s directory entry by a LINK statement to
another user’s device. This indirect linking continues
across the user directory entries until the defined limit of
such indirect links is exceeded. This limit is considered
exceeded when the device’s defining MDISK statement
is not located within 50 indirect links.
System Action: System operation continues.
User Response: Have operations personnel correct
the number of indirect links associated with the device
in the CP user directory.
HCP1200E DASD vdev has not been redefined
because paging subsystem device
cannot be redefined.
Explanation: The user specified a multiple exposure
paging subsystem device in an attempt to redefine it to
another virtual device number. You may not redefine
paging subsystem devices.
System Action: System operation continues.
User Response: To redefine a multiple exposure
paging subsystem device, detach it and then have the
system operator attach it to you as the desired virtual
device.
HCP1201E Device vdev cannot be readied because
it is active.
Explanation: You issued the READY vdev command
but the device vdev is active.
System Action: The system does not execute the
command.
Operator Response: Reissue the command.
232 z/VM: System Messages and Codes — CP
HCP1202E Device vdev was not rewound because
it is active.
Explanation: You issued the REWIND vdev
command, but the device vdev is active.
System Action: The system does not execute the
command.
Operator Response: Reissue the command.
HCP1249I Device rdev cannot be varied
subchannel {disable|enable} because a
time-out condition occurred
Explanation: The user entered a VARY command to
disable or enable a subchannel and a time-out condition
occurred.
System Action: CP command processing terminates
and system operation continues.
User Response: Enter the command again. If the
condition persists, contact your system support
personnel.
HCP1250I Device rdev cannot be varied online
because a time-out condition occurred.
Explanation: The indicated device is not brought
online because it failed to complete an I/O operation in
the given amount of time. An I/O operation must
complete within five seconds for the real machine, and
within five minutes for a virtual machine.
System Action: The device is not brought online.
User Response: None.
Operator Response: If this error occurs during IPL,
try to vary the device online after IPL.
This is probably a hardware malfunction. Notify your
system support personnel.
HCP1251I Device rdev cannot be varied online
because it requires operator
intervention.
Explanation: The indicated device is not brought
online because it is in an intervention-required state or,
in some cases, because it is not physically connected to
the control unit.
rdev identifies the device that is not being brought
online.
System Action: The device is not brought online.
Operator Response: Ready the device and vary it
online.