z/VM: System Messages and Codes Š CP - z/VM - IBM

HCQ097E HCQ106E
System Action: The subcommand or macro
terminates.
User Response: Enter the subcommand or macro
again using a correct VMDBK address or user ID.
HCQ097E Unexpected response received from
CPU subcommand
Explanation: Some subcommands and macros
depend on the output of the CPU subcommand to
determine information about the CPUs represented in
the dump. In this case, the response was not in the
expected format.
System Action: The subcommand or macro
terminates.
User Response: Enter the CPU subcommand directly
and see if produces normal output. If the problem
persists, contact your IBM Support Center.
HCQ098E Index xxx beyond table size of yyyyyy
Explanation: This probably indicates an error in either
the requested subcommand or macro or in the CP
tables in the dump used for address translation. An
index value from one level to the next being used to
translate a CP address was found to be out of range.
System Action: The subcommand or macro
terminates.
User Response: Contact your IBM Support Center.
HCQ099E Index index within table offset offset,
below actual table start address -
address
Explanation: This probably indicates an error in either
the requested subcommand or macro or in the CP
tables in the dump used for address translation. An
index value from one level to the next being used to
translate a CP address was found to be out of range.
System Action: The subcommand or macro
terminates.
User Response: Contact your IBM Support Center.
HCQ100I ASCE is a real space designation, no
translation applies
Explanation: The address provided as input is
mapped 1–1 in real space. Thus, the translated address
is the same as the input address.
System Action: Processing continues.
User Response: No action is required, this is an
informational message.
482 z/VM: System Messages and Codes — CP
HCQ101E Region region index non-zero
Explanation: The ASCE for the address provided is
an STD, RSTD, or RTTD. The index for the indicated
Region table is non-zero, which is inconsistent. The
provided input address is not translatable via this ASCE.
System Action: Processing terminates.
User Response: Issue the subcommand again with a
different address.
HCQ102E ASCE format is not recognized
Explanation: The ASCE used in the translation of the
address provided is not an STD, RSTD, or RTTD. The
provided input address is not translatable via this ASCE.
System Action: Processing terminates.
User Response: Issue the subcommand again with a
different address.
HCQ103E TT bits level mismatch in valid table at
address: data
Explanation: The TT bits in the indicated table are
inconsistent with the rest of the table structure. The
provided input address is not translatable via this ASCE.
System Action: Processing terminates.
User Response: Issue the subcommand again with a
different address.
HCQ104I Name HCPCPE not found
Explanation: In trying to create a map of the modules
in storage, the last resident module of CP, HCPCPE,
could not be found in the dump.
System Action: Processing continues.
User Response: No action is required. If the problem
persists, contact the IBM Support Center.
HCQ105E Error getting controlblock
Explanation: An error was encountered when trying to
access the indicated control block. This error may have
resulted from either reading the actual dump file, or that
the required page was not included in the dump.
System Action: The subcommand or macro
terminates.
User Response: If the problem persists, contact the
IBM Support Center.
HCQ106E ADDRSCAN is set OFF - command
Explanation: The indicated command was received by
Address SCAN from a macro, but the Address Scan
environment is not active.