z/VM: System Messages and Codes Š CP - z/VM - IBM

HCP2205I type rdev HAS BEEN VARIED OFFLINE
Explanation: The system has varied device rdev
offline.
The type variable in the message identifies the error
recovery routine.
Type Error Recovery Routine
DASD Disk
LINE Line
TAPE Tape
System Action: The system prevents any further I/O
to the device until it is varied online.
Operator Response: Correct the condition that
caused the device to be varied offline and vary the
device back online.
HCP2206A THE VOLUME MOUNTED ON DASD
rdev DOES NOT HAVE VOLID label
Explanation: The volume label on the pack mounted
on the device does not match the label expected. The
variables in this message are as follows:
rdev The unit address of the failing device
label The label expected
System Action: The system does not proceed with
I/O to this device until the proper volume is mounted.
Operator Response: Check the pack that is mounted
on the device. The volume label for that volume should
match the one in the message. It is possible that a pack
was mounted on the wrong device or that a volume
label was accidentally changed.
HCP2207A type rdev THE ERROR COUNT
EXCEEDED THE THRESHOLD
Explanation: The large number of errors occurring on
device rdev prevent any further use of the device. The
type in the message identifies the error recovery
routine:
Type Error Recovery Routine
DASD Disk
GRAF Display device
LINE Line
RDR Reader
PRT Printer
PUN Punch
System Action: The system prevents any future I/O to
the device and cancels any current I/O to the device.
User Response: If the system continues operating,
transfer work from the failing device to another available
HCP2205I HCP2210A
device, if possible. Notify your system support
personnel.
Programmer Response: Examine the EREP outboard
recorder (OBR) record within LOGREC for specific
hardware error conditions and contact your IBM Support
Center personnel to diagnose and correct the hardware
error.
HCP2208A THE EQUIPMENT CHECK COUNT FOR
DASD rdev EXCEEDED THE
THRESHOLD
Explanation: Continuous equipment checks occurred
on the device. This indicates possible damage to the
recording media. The rdev variable refers to the failing
device.
System Action: The system will no longer accept I/O
for this device, and all current I/O requests are
cancelled.
Operator Response: Turn off the drive and notify your
system support personnel. If the device has a
removable pack, do not try to remount the pack.
Programmer Response: Examine the OBR (outboard
recorder) record within LOGREC for specific hardware
error conditions and contact your IBM Support Center
personnel to diagnose and correct the hardware error.
HCP2209I PRT rdev AN OPERATION WAS
TERMINATED BECAUSE A COMMAND
SUPPRESSION ERROR OCCURRED
Explanation: A command suppression occurred during
printer error recovery. This error indicates an interface
disconnection before channel end has been signaled.
Failing device rdev is identified in the message text.
This message is displayed in conjunction with other
messages that provide information about channel
command word, sense, user ID, and other variables
when necessary.
System Action: System operation continues.
Operator Response: Contact your system support
personnel. This is probably a software error.
HCP2210A TAPE rdev REQUIRES OPERATOR
INTERVENTION; RELOAD CARTRIDGE
Explanation: The tape cartridge on device rdev is not
inserted correctly, or the tape is not threaded correctly.
This message is displayed in conjunction with other
messages that provide information about channel
command word, sense, user ID, and other variables
when necessary.
System Action: System operation continues.
User Response: Reload the cartridge into the drive
and retry the operation. If the problem persists, contact
Chapter 3. System Messages 269