z/VM: System Messages and Codes Š CP - z/VM - IBM

HCP2828E SCPDATA length exceeds maximum
allowed (nnnn)
Explanation: The specified data is too long or, in the
case of appending or overlaying existing data, the
resulting string is too long. nnnn is the maximum
allowable length.
System Action: The command is not executed; no
LOADDEV data is modified.
User Response: None
HCP2829E SCPDATA does not contain a valid hex
string
Explanation: An odd number of characters was
entered or the data contains characters other than 0-F.
An even number of characters is required because each
byte of data is represented by two hex characters.
System Action: The command is not executed; no
LOADDEV data is modified. If the error is from a
directory statement, then the statement is skipped.
User Response: Correct the error and issue the
command.
HCP2830I The variations of this message are
explained below.
MESSAGES: VSWITCH SYSTEM switchnm status is
v defined
v controller not available
v disconnected following error. userid was last
VSWITCH controller
v disconnected requiring operator intervention. userid
was last VSWITCH controller
v devices attached. userid is VSWITCH controller
v initialization in progress. userid is VSWITCH
controller
v device not ready. userid is VSWITCH controller
v ready. userid is VSWITCH controller
v device detach in progress. userid is VSWITCH
controller
v detach VSWITCH pending. userid is VSWITCH
controller
v in error recovery. userid is new VSWITCH controller
v restarting. userid is VSWITCH controller
Explanation: A virtual switch is defined with a real
device address to connect it to a QDIO OSA Express
device. This message is used to report changes in the
status of the connection to that device.
v defined
The virtual switch is created, but no real device
address has been specified.
v controller not available
A TCP/IP virtual switch controller is not available to
manage the device. The connection to the real
hardware LAN is not operational.
v disconnected following error. userid was last
VSWITCH controller
The virtual switch is created, but the connection to
the real hardware LAN is not operational.
v disconnected requiring operator intervention.
userid was last VSWITCH controller
The virtual switch is created, but the connection to
the real hardware LAN is not working. The operator
must take action to make it operational.
v devices attached. userid is VSWITCH controller
The OSA Express devices are attached to a virtual
switch controller, but the connection to the real
hardware LAN is not operational.
v initialization in progress. userid is VSWITCH
controller
Initialization of the OSA Express devices has begun.
The connection to the real hardware LAN is not
operational.
v device not ready. userid is VSWITCH controller
Initialization has completed, but the virtual switch
controller received a response from the device
indicating that the device is not ready. The
connection to the real hardware LAN is not
operational.
v ready. userid is VSWITCH controller
The connection to the real hardware LAN is
operational.
v device detach in progress. userid is VSWITCH
controller
The connection to the real hardware LAN is not
operational.
v detach VSWITCH pending. userid is VSWITCH
controller
The virtual switch is being removed from the system.
v in error recovery. userid is new VSWITCH
controller
An error occurred and the system is attempting to
recover by switching to a backup OSA Express
device and virtual switch controller.
v restarting. userid is VSWITCH controller
An error occurred but there is no backup device
operational for the virtual switch. The system is
attempting to restart the failing device.
System Action: System operation continues.
System Programmer Response: The OSA Express
device is controlled by a z/VM TCP/IP virtual machine
acting as the virtual switch controller. In some cases,
the suggested action is to issue z/VM TCP/IP
commands or investigate messages on the z/VM
TCP/IP console.
v defined
HCP2828E HCP2830I
Chapter 3. System Messages 315