z/VM: System Messages and Codes Š CP - z/VM - IBM

HCP248E HCP260E
User Response: None.
HCP248E SPECIFIED IMAGE imagename
NON-EXISTENT
Explanation: CP cannot locate the text deck you
specified as an image library member imagename.
Creation of the image library does not take place.
System Action: Command processing terminates;
system operation continues.
User Response: If the member was not supposed to
be included in the library, remove the entry imagename
from the control file and reissue the IMAGELIB
command. If the member was to be included, make
certain there is a file “imagename TEXT” on one of your
disks. If it does not exist, you have to recreate it using
the GENIMAGE command.
HCP249E ERROR LOADING IMAGE imagename
Explanation: CP could not load the text deck you
specified as an image library member imagename into
your virtual storage. Creation of the image library does
not take place.
System Action: The command processing terminates;
system operation continues.
User Response: If the member was not supposed to
be included in the library, remove the entry imagename
from the control file and reissue the IMAGELIB
command. If the member was to be included, take the
necessary action to correct the problem in accessing
the CMS file.
HCP254E ERROR SAVING imagelib; RC = rc
Explanation: An error occurred while CP was saving
the 3800 image library. Creation of the image library
does not take place.
Code Reason
8 The image library is currently active.
24 A paging error occurred while CP was
processing this request.
32 Spool space is full.
36 Abnormal termination occurred. CP issued soft
abend NSI001.
40 The specified filename was invalid because it
was not alphanumeric.
44 No spool IDs are available.
System Action: The command processing terminates;
system operation continues.
User Response:
Code Action
8 Purge the old image library and reissue the
156 z/VM: System Messages and Codes — CP
command. When the printer is drained and
started during normal operation, the system
picks up the new library.
24 Reissue the command. If the problem persists,
contact system support personnel.
32 Purge any unnecessary spool files or system
data files.
36 Reissue the command. If the problem persists,
contact system support personnel.
40 Reissue the command with an alphanumeric
filename.
44 Purge any unnecessary spool files or system
data files.
HCP255E PRINTER rdev; PAGE BUFFER
DESTROYED, BACKUP PAGE COUNT =
nnnn
Explanation: A certain number of pages (nnnn) on the
photoconductor drum or in the page buffer of the device
(rdev) were lost.
This message is displayed in conjunction with other
messages that provide information about channel
command word, sense, user ID, and other variables
when necessary.
System Action: System operation continues.
Operator Response: Using the backup page count
given and the size of the files just requeued, determine
how far to backspace the current file using the
BACKSPACE command. Also, determine whether or not
you want to replace the requeued files for printing. Use
the BACKSPACE command, with the EOF option, to
reprint the end of any requeued file when it begins
printing again. Issue the CP START command to
reinitiate printing operation.
HCP259E SIZE parameter missing or invalid
Explanation: The SIZE keyword is specified, and the
parameters are either not specified or not valid 3800
parameters.
System Action: System operation continues.
User Response: Reissue the command specifying the
SIZE parameters correctly.
HCP260E {Command|command command}
processing cannot complete due to
errors.
Explanation: Processing of the command operation
requested cannot complete because CP detected one
or more errors.
System Action: The command processing terminates.
User Response: Determine the cause of the error as