z/VM: System Messages and Codes Š CP - z/VM - IBM

HCQ051E Reason code code on TOD conversion
Explanation: The indicated reason code was received
from the DATETIMESUBTRACT CSL routine.
System Action: The subcommand or macro
terminates.
User Response: Examine the meaning of the reason
code in z/VM: CMS Callable Services Reference; then
enter the subcommand again.
HCQ052E Unknown CPU number - cpuno
Explanation: The CPU number indicated is not
represented in the dump.
System Action: The subcommand or macro
terminates.
User Response: Enter the subcommand or macro
again with a correct CPU number.
HCQ053E xxxxxxxx is not * or a decimal number
Explanation: The indicated value is not an asterisk or
a valid decimal number.
System Action: The subcommand or macro
terminates.
User Response: Enter the subcommand again with an
asterisk or decimal number.
HCQ054W Offset incorrect, set to nnnnn
Explanation: The absolute offset value is larger than
the display area of the screen or zero, or an increased
or decreased indentation value has caused output to
shift off the left or right side of the viewing area.
System Action: Processing continues with the indent
offset value set to 0.
User Response: Enter the subcommand or macro
again with a correct offset value.
HCQ055E length too large, yyy max
Explanation: The value indicated is greater than the
allowed maximum of yyy.
System Action: The subcommand or macro
terminates.
User Response: Enter the subcommand or macro
again with a value in the right range.
HCQ056E Must be run in a VMDUMPTL
environment
Explanation: An XEDIT macro was invoked that
requires the VM Dump Tool to run, but the VM Dump
Tool is not a active.
System Action: The macro terminates.
User Response: Bring up the VM Dump Tool
(VMDUMPTL EXEC) and enter the macro again.
HCQ057E Address cannot be resolved - addr
Explanation: An error was encountered when trying to
resolve the indicated symbol or address. If a symbol
was found, it is shorter than 6 characters or longer than
8. If an open parenthesis was found, the next character
was not G or R or the register number was not between
0 and F or 0 and 15. If a plus sign or dash was found,
no value was found after that character.
System Action: The subcommand or macro
terminates.
User Response: Correct the indicated value and enter
the subcommand or macro again.
HCQ058E Error nn on STATE for file fn ft
Explanation: The indicated error was received from a
STATE on the BLOCK library file listed.
System Action: The file is not used to find BLOCK
definition information.
User Response: See the STATE command in the
z/VM: CMS Commands and Utilities Reference for a
description of the command and its responses.
HCQ059E Unknown {real
device|subchannel|virtual device}
Explanation: The real or virtual device or subchannel
cannot be located in the dump.
System Action: The subcommand or macro
terminates.
User Response: Locate and correct the item indicated
and enter the subcommand or macro again.
HCQ060E macroname supports only CP dumps
Explanation: Many subcommands and macros
reference CP data structures to locate information. The
dump currently being processed is not recognized as a
CP dump.
System Action: The macro terminates.
HCQ051E HCQ061E
User Response: If this is not a CP dump, then this
subcommand or macro cannot be used.
HCQ061E Unknown -
value
Explanation: The input value was not found to be
either a user ID or a VMDBK address.
System Action: The subcommand or macro
terminates.
User Response: Locate the correct user ID or
Chapter 3. System Messages 477