z/VM: System Messages and Codes Š CP - z/VM - IBM

HCP9260E type rdev SYSTEM DUMP FAILURE;
FATAL I/O ERROR
Explanation: An irrecoverable I/O error occurred
during a system abend dump which was being directed
to the specified device type (type) at the specified real
device (rdev). The system abend dump is unable to
continue.
System Action: The current system dump is
terminated, and normal system recovery procedures are
continued.
User Response: No action can be taken at this point
to recover the remainder of the system dump.
HCP9260I X% of the dump has been completed
Explanation: This message appears when a dump to
DASD or TAPE is being taken. It indicates what
percentage of the dump has been completed. This
message will be displayed when 25, 50, and 75 percent
of the dump has been completed.
The variables in this message are as follows:
X The percentage of the dump that has
completed.
System Action: Dump processing continues.
User Response: None.
HCP9261I Dumping complete
Explanation: This message appears when a dump to
DASD or TAPE has been completed.
System Action: Dump processing complete.
User Response: None.
HCP9262I PSW = xxxxxxxx xxxxxxxxx
Explanation: The program status word (PSW)
displayed is the PSW at the time of the system failure.
System Action: System operation continues.
Operator Response: None.
HCP9263I GREGS 0-7 = xxxxxxxx xxxxxxxx
xxxxxxxx xxxxxxxx xxxxxxxx xxxxxxxx
xxxxxxxx xxxxxxxx
Explanation: The general purpose registers are
displayed at the time of a system failure.
System Action: System operation continues.
Operator Response: None.
HCP9264I GREGS 8-15 = xxxxxxxx xxxxxxxx
xxxxxxxx xxxxxxxx xxxxxxxx xxxxxxxx
xxxxxxxx xxxxxxxx
Explanation: The general purpose registers are
displayed at the time of a system failure.
System Action: System operation continues.
Operator Response: None.
HCP9265I {The SNAPDUMP command has been
entered, causing|A system error has
caused} the non-destructive dump
function to be called. The System will
be quiesced until the dump is
complete.
Explanation: One of the following occurred:
v A privileged user entered the SNAPDUMP command
to request a snapdump system dump.
v A system error requested a snapdump system dump.
The system could request a snapdump if the error:
v Caused it to be specifically requested
v Requested a soft abend that had been set to
snapdump with the use of the SET ABEND
command.
System Action: A snapdump is created to either the
dump device defined at system initialization or the dump
device specified by the use of the SET DUMP
command.
Operator Response: None.
HCP9260E HCP9266I
HCP9266I {A system error has caused the
non-destructive dump function to be
started|The SNAPDUMP command has
been entered|A soft abend re-defined
as SNAPDUMP has been started},
however the current dump setting is
OFF. No dump will be generated.
Explanation: SNAPDUMP processing was started
because of a system error, the SNAPDUMP command,
or because a soft abend redefined as snapdump was
hit. When the SET DUMP options were checked, the
current settings indicated that SET DUMP OFF had
been specified. Therefore, no dump will be generated.
System Action: SNAPDUMP processing terminates.
Operator Response: If you wish to receive future
dumps, enter the SET DUMP command again.
Chapter 3. System Messages 465