z/VM: System Messages and Codes Š CP - z/VM - IBM

Reason Description User Response
Incorrect
password
The password
supplied with the
XAUTOLOG or
AUTOLOG
command does
not match the
password in the
directory.
Contact your
system
administrator to
verify the correct
password, or to
reissue the
AUTOLOG or
XAUTOLOG
command with a
correct password.
If an external security manager (ESM) is installed on
your system, you may receive this message if you are
not authorized to issue this command.
User Response: Contact your system administrator to
obtain the necessary authorization.
HCP060E {Dump failed|Printer output
terminated}; virtual printer unavailable
Explanation: No virtual printer could be found.
System Action: System operation continues.
User Response: Use the DEFINE command to create
a virtual printer and reissue the command.
HCP061E Dump failed; virtual printer error
Explanation: The virtual printer failed because an I/O
error occurred while the dump was being spooled to
DASD.
System Action: System operation continues.
User Response: Notify the system programmer.
HCP067E Command format not valid
Explanation: The VMDUMP command could not
complete the dump. There was an error while writing
the reader spool file on DASD.
System Action: The system tries to close the spool
file. If the spool file closes successfully, it will be
available to the virtual reader you specified. Command
processing is terminated; system operation continues.
User Response: Notify the system programmer.
HCP068E SEND command failed; text
Explanation: The SEND command has failed.
text in this message identifies why the command failed.
System Action: In each case, the system action is the
same. No text is sent to the receiver.
v receiver has no virtual console
User Response: Define a virtual console for the
receiver.
v receiver is executing a console function
User Response: The receiving machine must
complete the console function before another CP
command can be sent. Resend the command at a
later time.
v receiver has console input waiting
User Response: The receiving virtual machine must
do a console read for input that is already waiting;
then the SEND command can be reissued.
v receiver has not authorized sender
User Response: The sender must be specified as a
secondary user of the receiver on the CONSOLE
directory statement.
v receiver is not disconnected
User Response: The SEND command may not be
used because the receiver is logged on at a terminal
and is controlling his own virtual machine.
HCP088E An invalid number was supplied for
{COPY|FLASH} - operand.
Explanation: The option specified requires that a
count be supplied. The operand given is either not a
decimal numeral, or is not in the range required by the
option.
System Action: The command is not executed.
System operation continues.
User Response: Reissue the command with a valid
count as specified by the command reference.
HCP090I Device vdev not defined; {rdev|volser}
not available
Explanation: The valid virtual device (vdev) has not
been defined in the virtual machine’s configuration
because the real device described in the directory
DEDICATE card is not available. A real device is
considered not available if it is in one of the following
situations:
v Already attached to another user
v In use by the CP system
v Offline.
System Action: System operation continues.
User Response: Ask the system operator about the
status and availability of the real device. The operator
can attach the required device or an alternate device to
the virtual machine.
HCP091E DASD vdev not defined; {temp|vdisk}
space not available
Explanation: The virtual device has not been defined
in the virtual machine configuration because space is
not available.
v temp space not available
HCP060E HCP091E
Chapter 3. System Messages 145