z/VM: System Messages and Codes Š CP - z/VM - IBM

v A valid block specification is one that is not larger
than the maximum number of blocks available on the
device type specified.
v A valid cylinder specification is one that is less than
four characters and not larger than the maximum
number of cylinders available on the device type
specified.
v A valid page specification is one that is not larger
than the maximum number of pages available on the
device type specified.
System Action: The command is not executed.
System operation continues.
User Response: Reissue the command, specifying
the correct number of blocks, cylinders, or pages.
HCP025E Storage missing or invalid
Explanation: The amount of storage is either missing
or invalid. A valid storage specification is either
nnnnnnnnK or nnnnM.
System Action: The command is not executed;
system operation continues.
User Response: Reissue the command; specify the
storage requirement.
HCP026E Operand missing or invalid
Explanation: A required operand is missing or invalid.
If an external security manager (ESM) is installed on
your system, you may receive this message if you are
not authorized to issue the specified operand.
System Action: The command is not executed;
system operation continues.
User Response: Reissue the command with a valid
operand or contact your system administrator to obtain
authorization to use this operand.
HCP028E Class missing or invalid
Explanation: The class value is either missing or
invalid. A valid class is in the range A through Z or 0
through 9, and one character in length.
System Action: The command is not executed;
system operation continues.
User Response: Reissue the command with a valid
class.
HCP030E Copies missing or invalid
Explanation: The operand that specifies the number
of copies is either missing or invalid. An invalid copy
specification is a nondecimal number or greater than
255.
System Action: The command is not executed;
system operation continues.
User Response: Reissue the command specifying the
required number of copies.
HCP031E Buffer missing or invalid; {FCB too
long|extended FCB not supported}
Explanation: One of the following occurred:
v The FCB is too long for the type of printer; it could
not be loaded.
v An attempt is made to send an extended FCB (forms
control buffer) image to a printer that does not
support the extended FCB format.
System Action: The system does not load the buffer
into the device.
User Response: Enter the command again using
either a valid buffer name or a buffer that is compatible
with the device.
HCP033E Hexloc missing or invalid
Explanation: The hexadecimal location either has
been omitted or incorrectly specified. A valid
hexadecimal location is one that contains hexadecimal
characters, is eight characters or less, and is aligned to
a machine address boundary if required by the
operation.
System Action: The command is not executed;
system operation continues.
User Response: Reissue the command with a valid
hexadecimal location.
HCP035E Device type missing or invalid
Explanation: The command requires that you enter a
valid CP spool device type as an operand, but it is
either missing or invalid. Valid device types are
READER (Reader, RDR), PRINTER (Printer, PRT), and
PUNCH (PU, PCH).
System Action: The command is not executed;
system operation continues.
User Response: Reissue the command with a valid
spool device type.
HCP036E Index missing or invalid
HCP025E HCP036E
Explanation: You specified the INDEX option on the
LOADBUF, LOADVFCB or START command with an
operand that was not in the range 1 to 31.
System Action: The command is not executed;
system operation continues.
User Response: Reissue the command with the
INDEX option in the range 1 to 31, or allow the INDEX
to default to the value coded in the specified FCB
(forms control buffer) image.
Chapter 3. System Messages 141