z/VM: System Messages and Codes Š CP - z/VM - IBM

HCP1460E HCP1507E
System Action: Execution of instructions and
interrupts terminates, the interval timer is not updated,
and console function mode is entered.
User Response: Enter the SYSTEM RESET or
SYSTEM CLEAR command to leave check-stop state. If
the problem persists, contact your system programmer.
The check-stop may be indicative of a more serious
error.
System Programmer Response: In the case of a
failed NSS or DCSS, resave the segment or system that
failed. If another DASD pack is available, use it to retry
the IPL. If the problem persists, contact your IBM
Support Center Personnel to diagnose and correct the
error.
HCP1460E Only one of the CPU commands may
specify multiple virtual CPUs when
entering nested CPU commands.
Explanation: More than one nested CPU command
specifying multiple virtual CPUs was entered.
System Action: The command is not executed.
System operation continues.
User Response: Enter the command again without
specifying multiple virtual CPUs on more than one
nested CPU command.
HCP1500E [XAUTOLOG failed for userid:] Logon
cannot be done because userid userid
is in system hold state.
Explanation: A user who had been placed in system
hold attempted to log on to the system. If the command
was an asynchronous XAUTOLOG, then the message
will indicate which user ID did not get logged on.
System Action: The LOGON request is denied.
User Response: Ask the system operator about the
status of the HOLD request. If the user is removed from
HOLD status, then the user can reenter the command.
HCP1501E An accounting error was encountered.
Explanation: The LOGON accounting routine returned
a nonzero return code.
System Action: The user is not logged on to the
system.
User Response: Contact your system programmer for
specific requirements for accounting procedures.
HCP1502E The directory entry for this userid is in
use.
Explanation: The directory entry for a user who is
logging on is already in use by LOGON processing.
This message is issued when someone else is logging
240 z/VM: System Messages and Codes — CP
on at the same time under the same virtual machine
user ID.
System Action: LOGON/AUTOLOG denied.
User Response: Attempt LOGON/AUTOLOG using
another user ID.
HCP1503E Hold status is not set because the hold
queue is full.
Explanation: A HOLD command was issued after the
maximum number of 32 users in the hold queue had
been reached.
System Action: System operation continues.
Operator Response: Enter the FREE command to
free a user from the hold queue.
HCP1505I The device being used for LOGON
conflicts with the {console definition in
the directory | current console
definition}
Explanation: A LOGON command was issued on a
non-3270 device for a user that has a 3270 console
defined in the directory, or a LOGON command was
issued on a non-3270 device to reconnect to a user
whose console is a 3270.
System Action: LOGON processing continues.
User Response: Disconnect and reconnect on a
compatible device.
HCP1506E The last line (50) in the log message is
already in use.
Explanation: You entered the SET LOGMSG
command without nn to add a message at the end of
the log message, but the last entry (50) is already in
use.
System Action: The command is not executed,
system operation continues.
User Response: Examine the log message for unused
or unneeded lines. Use the SET LOGMSG command to
free the last lines or reenter the SET LOGMSG with the
nn for specific log message placement.
HCP1507E The directory is not valid.
Explanation: During initial LOGON processing for the
system operator, or during subsequent system
operation, CP found the system directory to be invalid.
System Action: This message is sent to the system
operator to inform him or her to enter the DIRECTXA
command.
Operator Response: Enter the DIRECTXA command
to bring a valid directory online.