z/VM: System Messages and Codes Š CP - z/VM - IBM

HCP1509E You are not authorized to issue
XAUTOLOG with the PASSWORD or
PROMPT options.
Explanation: A class G user has entered the
XAUTOLOG command with either the PASSWORD or
PROMPT option.
System Action: The command is not executed;
system operation continues.
User Response: Directory authorization is the only
way for class G users to successfully issue
XAUTOLOG. Reenter the command with the
DIRECTORY (default) option instead of the
PASSWORD or PROMPT option.
HCP1510I Device vdev not defined; device vdev
already defined
Explanation: The virtual device specified is already
defined within the virtual machine's configuration. If the
type is CONSOLE, your console was not defined
because only one virtual CONSOLE is allowed on each
virtual machine configuration.
System Action: System operation continues.
User Response: Enter the command again; specify a
virtual device that is not already defined within the
virtual machine configuration, or detach the conflicting
virtual device before reentering the command.
If you want to redefine your console to some other
device type, you must first detach your current console
and then define the new one.
HCP1512E The System/370 machine mode was
requested, but CP does not support
System/370 mode virtual machines; the
machine mode will be set to XA
instead.
Explanation: The directory entry for this user specified
a machine mode that is not valid.
System Action: The user ID has been logged on, but
the machine mode was set to XA.
User Response: Specify a valid machine mode. To
run 370 applications, use the 370 Accommodation
Facility. Refer to z/VM: CP Programming Services for
more information.
HCP1513E [XAUTOLOG failed for userid:] A logon
is already in progress [on {type
rdev|type ldev|luname|SYSC}]
Explanation: The user ID you specified in a LOGON,
AUTOLOG, or XAUTOLOG command is already in the
logon process. If the message does not include the
terminal identification, then an AUTOLOG or
XAUTOLOG is being performed for that user.
Some terms used in this message are:
type Device type
rdev Real device number
ldev Logical device number
luname VTAM definition of the terminal as a SNA
logical unit
SYSC System console.
System Action: The command is not executed.
System operation continues.
User Response: No user action is required.
HCP1514E userid already disconnected
Explanation: An attempt to disconnect a user by
issuing the FORCE command failed because the user
was already disconnected.
System Action: The command is not executed;
system operation continues.
User Response: No user action is required.
HCP1515E Invalid operand operand passed on
MACHINE option.
Explanation: An operand that was not valid was
passed on the MACHINE option of the LOGON or
XAUTOLOG command.
System Action: Command is terminated.
User Response: Resubmit the command with a valid
MACHINE mode setting.
HCP1550E The variations of this message are
explained below.
MESSAGES:
v rdev is an invalid device class.
HCP1509E HCP1550E
v Device rdev device class does not match
requested device class.
Explanation: You issued a CP SET RDEVICE
command that tried to change the device class of a
device. The command failed for one of the following
reasons:
v CP does not recognize the specified device class as
a valid CP device, or
v CP cannot allow you to change the device class
because the RDEVICE is a different class than the
device type requested.
System Action: CP does not execute the command;
system operation continues.
User Response: Enter the command again and
specify a valid device class for the command, or correct
the CP SET RDEVICE command.
Chapter 3. System Messages 241