z/VM: System Messages and Codes Š CP - z/VM - IBM

HCP8085E HCP8101E
HCP8085E AN IUCV IPRCODE OF iprcode WAS
ENCOUNTERED DURING AN IUCV
{CONNECT|DCLBFR|RECEIVE|
REJECT|REPLY |RTRVBFR| SEVER}
FUNCTION.
Explanation: Record retrieval was in progress when a
communication error occurred. The IUCV function and
IPRCODE are displayed in the message.
System Action: System operation continues.
Operator Response: Investigate the error condition
and make the necessary corrections. The virtual
machine retrieval program should be checked to assure
CP record retrieval protocol is being followed. If the
error persists, contact your system support personnel.
HCP8086E The attempt to CONNECT to the
{*ACCOUNT|*LOGREC|*SYMPTOM|
*CONFIG} system service has failed for
user userid due to a protocol error.
Explanation: An attempt was made to establish
CP-to-virtual-machine communication to retrieve CP
records; the IUCV CONNECT was in error. The
CONNECT parameter list indicated that the user ID
specified will only handle message data contained in a
parameter list rather than a buffer. This is a protocol
error.
System Action: Processing continues.
User Response: None.
Operator Response: None.
Programmer Response: Check the virtual machine
retrieval program to ensure proper IUCV-to-CP
communication. Correct the situation and retry the
operation.
HCP8087I Records are queued for user userid on
the {*LOGREC|*ACCOUNT|*SYMPTOM|
*CONFIG} recording queue and must
be purged or retrieved before
recording can be turned on
Explanation: The ON option of the RECORDING
command has been issued, the indicated user’s
recording status is OFF and the user has a non-zero
number of records queued. Recording cannot be turned
ON for this user until the existing records are
processed.
System Action: CP will not change the recording
status of the user.
User Response: The queued records must be
processed by using the PURGE option of the
RECORDING command to purge the records from the
queue, or by issuing the CMS RETRIEVE command
from the user’s console to retrieve the system records.
432 z/VM: System Messages and Codes — CP
HCP8088I EREP LOGROUTE RECORDS ROUTED
TO userid AT nodeid
Explanation: This message is displayed when
RETRIEVE processing sends error records accumulated
in XAEREPSD RECORD to userid at nodeid.
System Action: System operation continues.
Operator Response: None.
HCP8089I LOGROUTE DEACTIVATED TO userid
AT nodeid FOR time
Explanation: This informational message is displayed
when a CP EXTERNAL command is entered and you
choose to end RETRIEVE command processing.
System Action: RETRIEVE processing ends. System
operation continues.
Operator Response: None.
HCP8090I LOGROUTE ACTIVATED TO userid AT
nodeid FOR time
Explanation: This informational message is displayed
by RETRIEVE command processing when the
LOGROUTE function is successfully activated.
System Action: System operation continues.
Operator Response: None.
HCP8100I DEFAULT PRINTER 000E DOES NOT
EXIST
Explanation: DDR uses device number 000E as the
default printer when no SYSPRINT control statement is
supplied.
System Action: The program continues with no printer
defined.
User Response: As soon as possible, define a valid
printer using the SYSPRINT control statement.
Note: When using cards as input, provide a valid
SYSPRINT control statement before any function
statements. If a valid printer is not defined, the
job step ends as soon as printer output is
attempted, causing the system to issue error
message HCP704E.
HCP8101E VERIFY PATH yy TO DEVICE xxxx; A
POTENTIAL CONFIGURATION
CHANGE WAS DETECTED.
Explanation: A reset event occurred on this path.
System Action: The program ends.
User Response: Verify that no configuration changes
have occurred and then retry the operation.