z/VM: System Messages and Codes Š CP - z/VM - IBM

HCP017E HCP024E
System Action: System operation continues.
User Response: This is an invalid command. No
action is possible.
HCP017E The variations of this message are
explained below.
MESSAGES:
v User userid has a SECUSER and cannot be
observed
v User userid is being observed and cannot have a
SECUSER
System Action: The designated observer relationship
is not established.
Explanation: CP issues these messages in response
to a CP SET SECUSER or SET OBSERVER command:
v The userid designated for observation by a SET
OBSERVER command cannot be observed because
the user has a secondary user defined.
v The userid designated as a primary user by a SET
SECUSER command cannot have a secondary user
because the user has an observer defined.
User Response: Determine if the secondary user can
relinquish control of the user or can provide the
information that direct observation of the user would
produce.
Determine if the observer can relinquish control of the
user or can provide the information that being the user’s
secondary user would produce.
HCP018E Spoolid missing
Explanation: The option or command specified
requires that you supply a spool ID, but you did not.
System Action: The command is not executed;
system operation continues.
User Response: Reissue the command with the
missing spool ID.
HCP020E Userid missing or invalid
Explanation: You have not supplied a user ID, or the
one you specified is invalid.
System Action: The command is not executed;
system operation continues.
User Response: Reissue the command, specifying a
valid user ID.
HCP021E The variations of this message are
explained below.
MESSAGES:
v A [real] device number was not supplied or it is
invalid.
140 z/VM: System Messages and Codes — CP
v A Diagnose code was not supplied or it is not
valid
Explanation: A real device number (rdev), a virtual
device number (vdev), or a DIAGNOSE code needs to
be specified but was not supplied or is not valid. Valid
(real or virtual) device numbers are 1- to 4-digit
hexadecimal numbers; valid DIAGNOSE codes are
hexadecimal numbers divisible by 4.
System Action: The command is not executed;
system operation continues.
User Response: Enter the command again and
specify a valid real device number, virtual device
number, or DIAGNOSE code.
HCP022E A virtual device number was not
supplied or it was invalid.
Explanation: The virtual device number (vdev) is not
present or is not valid. A valid virtual device number has
all of the following characteristics:
v Four characters or less
v Hexadecimal data
v Less than X'FFFF'
Note: If a previous IPL was successful, but an
abbreviation is used for a subsequent invocation
of another IPL instead of entering the entire
command, this error message is issued.
System Action: The command is not executed;
system operation continues.
User Response: Reissue the command with a valid
virtual device number. If you need to re-IPL, do not
enter an abbreviation of the IPL command; enter the
IPL command in its entirety.
HCP023E VOLID missing or invalid
Explanation: The volume identification (volid) is either
missing or invalid. A valid volume ID is six characters or
less.
System Action: The command is not executed;
system operation continues.
User Response: Reissue the command with a valid
volume identification.
HCP024E The variations of this message are
listed below.
MESSAGES:
v {CYLINDERS|PAGES} MISSING OR INVALID
v {Block number|Cylinder|Cylinder or block
numbers} missing or invalid
Explanation: The command requires the number of
blocks, cylinders, or pages be supplied, but this number
is either missing or not valid.