z/VM: System Messages and Codes Š CP - z/VM - IBM

HCP8442E HCP8457W
User Response: None
HCP8442E YOU CANNOT RESTORE THE 2CC
DIRECTLY TO THE 2CC DISK
Explanation: The user is trying to recover the 2CC
disk by writing over it. This is not valid.
System Action: Processing stops.
User Response: Select a disk address other than
2CC to be specified as the recover disk.
HCP8445E THE { DIRECTORY | FILEPOOL } name
IS NOT AVAILABLE
Explanation: The specified directory or filepool is not
available.
System Action: Processing stops.
User Response: Correct the error and re-issue the
command.
HCP8446I THE FOLLOWING COMPONENT WAS
ALREADY MOVED TO SFS: component
Explanation: The user selected a component that was
previously moved.
System Action: Processing stops.
User Response: Correct the error and reissue the
command or contact IBM Support for assistance.
HCP8449E THE SUBDIRECTORY dirname COULD
NOT BE CREATED
Explanation: The specified directory could not be
created.
System Action: Processing stops.
User Response: Contact IBM Support for assistance.
HCP8450E ACCESS OF dirname AT FILE MODE
filemode FAILED WITH RC=rc
Explanation: The access of the specified SFS
directory at the specified filemode failed with the
displayed return code.
System Action: Processing stops.
User Response: Correct the error and reissue the
command or contact IBM Support for assistance.
HCP8451W VMFERASE FAILED ON
SUBDIRECTORY dirname WITH RC=rc
Explanation: The VMFERASE command failed with
the specified return code.
System Action: Processing stops.
User Response: Contact IBM Support for assistance.
446 z/VM: System Messages and Codes — CP
HCP8452W SEGBLIST SEGDATA TABLE WAS NOT
UPDATED FOR THE FOLLOWING
COMPONENT: component
Explanation: The VMSES table specified in the
message was not updated due to a processing error.
System Action: Processing continues.
User Response: Contact IBM Support for assistance.
HCP8453I MOVE OF component COMPONENT TO
SFS COMPLETED SUCCESSFULLY
Explanation: The specified component was
successfully moved to SFS.
System Action: None
User Response: None
HCP8454E THERE ARE NOT ENOUGH FREE FILE
MODES AVAILABLE. nn ARE
REQUIRED
Explanation: There are not enough free filemodes
available to complete the EXEC processing.
System Action: Processing stops.
User Response: Free the required filemodes by
releasing unneeded accessed minidisks or SFS
directories.
HCP8455W command COMPLETED WITH
WARNINGS
Explanation: The specified command completed, but
warnings were issued. These are not severe enough to
impact install processing, but should be investigated to
ensure system stability.
System Action: None
User Response: Investigate all warnings before
completing install processing.
HCP8456I PROCESSING COMPONENT component
Explanation: This message is for your information.
System Action: None
User Response: None
HCP8457W SEGBLIST SEGDATA TABLE WAS
ALREADY UPDATED FOR component
Explanation: The specified table was already updated.
System Action: Processing continues.
User Response: None