z/VM: System Messages and Codes Š CP - z/VM - IBM

HCP6309I type rdev A PERMANENT EQUIPMENT
MALFUNCTION OF THE ALTERNATE
STORAGE DIRECTOR OCCURRED
Explanation: There exists either a permanent
equipment malfunction of the alternate storage director
or a state save operation in the reporting storage
director on device rdev.
This message is displayed in conjunction with other
messages that provide information about channel
command word, sense, user ID, and other variables
when necessary.
System Action: System operation continues.
Operator Response: There is probably a hardware
error. Contact your system support personnel.
Programmer Response: Contact your IBM Support
Center personnel to diagnose and correct the hardware
problem.
HCP6310I type rdev AN EQUIPMENT CHECK WITH
PERMANENT PATH ERROR
OCCURRED
Explanation: CP detected a permanent equipment
check in the logical path from the storage director to the
device rdev, and the path is now unavailable.
This message is displayed in conjunction with other
messages that provide information about channel
command word, sense, user ID, and other variables
when necessary.
System Action: System operation continues.
Operator Response: None.
HCP6311I type rdev AN OPERATION WAS
TERMINATED BECAUSE A CHANNEL
PROGRAM CHECK OCCURRED
Explanation: The channel program contained a
programming error on device rdev.
This message is displayed in conjunction with other
messages that provide information about channel
command word, sense, user ID, and other variables
when necessary.
System Action: System operation continues.
Operator Response: None.
HCP6312I type rdev AN OPERATION WAS
TERMINATED BECAUSE A CHANNEL
PROTECTION CHECK OCCURRED
Explanation: The channel attempted either to store
into or to fetch from protected storage on device rdev.
This is a programming error.
This message is displayed in conjunction with other
messages that provide information about channel
command word, sense, user ID, and other variables
when necessary.
System Action: System operation continues.
Operator Response: None.
HCP6309I HCP6321I
HCP6313A type rdev IS WRITE INHIBITED
Explanation: A write command is received for device
rdev which has its R/W - read only switch in the read
only position.
This message is displayed in conjunction with other
messages that provide information about channel
command word, sense, user ID, and other variables
when necessary.
System Action: System operation continues.
Operator Response: If write operations are allowed to
this device, set the switch to the R/W position.
Otherwise, take no action.
HCP6314I type rdev A CHANNEL CHAINING
CHECK OCCURRED
Explanation: A channel-chaining check occurred on a
channel associated with device rdev.
This message is displayed in conjunction with other
messages that provide information about channel
command word, sense, user ID, and other variables
when necessary.
System Action: System operation continues.
Operator Response: There is probably a hardware
error. Contact your system support personnel.
Programmer Response: Contact your IBM Support
Center personnel to diagnose and correct the hardware
problem.
HCP6315I rdev THE LABEL IS DAMAGED
Explanation: The DASD error recovery program
detected a change in the volume serial number.
System Action: System operation continues.
Operator Response: Report the problem to your
system administrator.
HCP6321I type rdev AN OPERATION WAS
TERMINATED BECAUSE RECORD
count WAS NOT FOUND
Explanation: CP cannot locate the record at the
specified address count in the search argument on
device rdev. This is probably a programming error.
This message is displayed in conjunction with other
messages that provide information about channel
command word, sense, user ID, and other variables
when necessary.
Chapter 3. System Messages 369