z/VM: System Messages and Codes Š CP - z/VM - IBM

HCP2752E Exit {number exit does|numbers
[exit1-exit2] do} not exist
Explanation: An unknown CP exit point number (or a
range of unknown CP exit point numbers) was specified
on one of the following commands:
v ASSOCIATE EXIT
v DISABLE EXITS
v DISASSOCIATE
v ENABLE EXITS
v LOCATE XITBK
v QUERY EXITS.
Most variations of this message will display the
unknown CP exit point numbers that were specified on
the command. If this message does not display any
numbers, then you do not have any CP exit points
defined on your system.
System Action: CP rejects the command; system
operation continues.
User Response: Enter the command again and
specify an existing CP exit point number or a range of
existing CP exit point numbers.
If there are no CP exit points established on your
system, which would be done by ASSOCIATE EXIT,
then you cannot change or interrogate them or their
control blocks.
HCP2753E The {specified|requested} control entry
point caused CPXLOAD to fail
reason
Explanation: CP did not load the customer-written CP
routines because there was a problem with the entry
point specified with the CONTROL operand. The
problem occurred because of the specified reason:
Cannot find the specified entry point
CP tried to locate the entry point name
specified by the CONTROL keyword, but could
not find it. Perhaps the entry point name was
misspelled or had not been loaded.
It is a TEMPORARY entry point
CP did locate the entry point name specified by
the CONTROL keyword. Unfortunately, the
entry point name was loaded by a prior
CPXLOAD that specified TEMPORARY. A
TEMPORARY CPXLOAD entry point name
may not be used as the control entry point
name for a different CPXLOAD request.
The specified entry point was marked for deletion
The entry point name specified by the
CONTROL keyword was marked for deletion
by a ".DEL" TEXT-file statement or by a
CHANGE directive.
HCP2752E HCP2755E
Cannot call the specified entry point
CP tried to call the entry point name, but the
attempt failed. This could be because there
exists a mismatch between the related ICRBK
and ICLBK control blocks, or other internal
mismatch.
The specified entry point rejected the CPXLOAD
request with return code nn
CP called the entry point name and the entry
point returned a nonzero return code of nn.
Any nonzero return code directs CP to reject
the request.
System Action: CP rejects the command; system
operation continues.
User Response: Your action depends on the indicated
reason:
Cannot find the specified entry point
Make sure that the specified entry point name
is correct.
It is a TEMPORARY entry point
Make sure that the specified entry point name
is loaded PERMANENT.
The specified entry point was marked for deletion
Make sure that the specified entry point name
is not marked to be deleted so that CP can call
it.
Cannot call the specified entry point
Investigate why CP could not call the entry
point. You may need to establish TRSOURCE
tracing or even cause a system dump.
The specified entry point rejected the CPXLOAD
request with return code nn
Investigate why the entry point rejected the
request.
HCP2754E Language xxxxx for Component yyy
does not exist
Explanation: A language and component was
specified on the DISASSOCIATE MESSAGES
command that is not already associated with an entry
point.
System Action: The command is not processed.
User Response: Use the QUERY CPLANGUAGE
ASSOCIATED command to determine the correct
language and component identifier then enter the
command again with the corrected information.
HCP2755E Encountered I/O error while loading
cards
Explanation: An I/O error occurred while CP was
loading cards from the customer-written CP routines into
CP storage.
System Action: CP rejects the CPXLOAD command
Chapter 3. System Messages 301