z/VM: System Messages and Codes Š CP - z/VM - IBM

HCP1102E DASD rdev has not been attached
because the paging subsystem is
already owned by userid.
Explanation: An attempt has been made to attach a
multiple-exposure paging subsystem device that is
already under the control of another user. A user
controls the entire subsystem, even if only one device is
attached.
System Action: The command is not executed;
system operation continues.
User Response: Wait until the controlling user
detaches the subsystem devices, then reissue the
ATTACH command.
HCP1103E DASD rdev has not been attached
because a real DASD paging
subsystem must map to only one
virtual paging subsystem.
Explanation: The user already has a multiple
exposure paging subsystem device attached. An
attempt has been made to attach a real multiple
exposure device from the same real subsystem to what
would be a different virtual subsystem for that user. A
real subsystem must map to only one virtual subsystem.
System Action: The command is not executed;
system operation continues.
User Response: Reissue the command with a valid
virtual device number.
HCP1104E DASD rdev has not been attached
because multiple real DASD paging
subsystems must not map to the same
virtual DASD paging subsystem.
Explanation: The user already has a multiple
exposure paging subsystem device attached. An
attempt has been made to attach a real multiple
exposure device from a different real subsystem to the
same virtual subsystem. A virtual subsystem must
consist of devices from only one real subsystem.
System Action: The command is not executed;
system operation continues.
User Response: Reissue the command with a valid
device number.
HCP1105E Tape rdev not attached; tape assigned
elsewhere.
Explanation: The 3480 tape rdev subsystem
requested by the user is already assigned to another
system.
System Action: System operation continues.
Operator Response: Try to attach a different tape
drive.
HCP1102E HCP1110E
HCP1107E command failed; I/O error on tape rdev
Explanation: The command cannot be executed
successfully because of an I/O error on the specified
device.
System Action: The command is not executed;
system operation continues.
User Response: Ensure that the device and control
unit are powered on and enabled. Then reissue the
command.
HCP1108E CP is unable to complete the ATTACH
XSTORE command. Expanded Storage
is not attached [to userid].
Explanation: CP was unable to complete attaching
Expanded Storage to the user in the message or to the
user who received the message if no user is given. The
ATTACH command failed. A soft abend dump has been
taken.
System Action: CP cancels the attach command and
returns the area that would have been attached to CP
use.
User Response: Contact the system programmer,
who should examine the soft abend dump.
Operator Response: Contact the system programmer,
who should examine the soft abend dump.
HCP1109E The command command cannot be
processed for device rdev because the
device is the secondary in a duplex
pair.
Explanation: A device is a secondary in a duplex pair.
When two volumes are in the duplex, duplex pending,
or failed duplex states, only the primary volume is fully
functional to the attaching host systems. The secondary
volume will accept only a selected subset of commands.
Refer to the appropriate storage control manual for
additional dual copy information. You may have
specified an incorrect device number.
System Action: System operation continues.
Operator Response: If an incorrect device number
was specified, reissue the command to the correct
device.
HCP1110E Device {rdev|vdev} is not in a duplex
pair.
Explanation: This message is displayed when the
device is not a primary or secondary device. You may
have specified an incorrect device number.
System Action: System operation continues.
Operator Response: Reissue the command to the
correct device.
Chapter 3. System Messages 227