z/VM: System Messages and Codes Š CP - z/VM - IBM

HCP526I HCP533I
HCP526I TAPE rdev AN OPERATION WAS
TERMINATED BECAUSE A DATA
SECURITY ERASE (DSE) CHECK
OCCURRED
Explanation: Tape drive rdev was not ready after the
Data Security Erase (DSE) command was issued, or an
error occurred while the command was processing,
causing a timeout condition to exist on communication
lines.
This message is displayed in conjunction with other
messages that provide information about channel
command word, sense, user ID, and other variables
when necessary.
System Action: System operation continues.
Operator Response: Rewind the tape and retry the
operation. If the problem persists, contact your system
support personnel.
HCP529I PRT rdev BUFFER PARITY ERROR
OCCURRED
Explanation: The spooling error recovery routine (for
PRT) found an unrecoverable parity error in either the
print line or the universal character set (UCS) buffer.
This message is displayed in conjunction with a
message that specifies the sense data. Sense byte 3,
bit 0 indicates that the parity error occurred in the
universal character set (UCS) buffer. Sense byte 3, bit 1
indicates that the parity error occurred in the print line
buffer.
rdev in the message identifies the failing device.
This message is displayed in conjunction with other
messages that provide information about channel
command word, sense, user ID, and other variables
when necessary.
System Action: System operation continues.
Operator Response: This is probably a hardware
error. If the problem persists, contact your system
support personnel.
Programmer Response: Examine the MDR
(miscellaneous data record) record within LOGREC for
specific hardware error conditions. If the problem
persists, contact your IBM Support Center personnel to
diagnose and correct the hardware problem.
HCP530I graf rdev A UNIT SPECIFICATION
OCCURRED
Explanation: The display error recovery routine
detected an irrecoverable device-detected error on the
failing device rdev.
This message is displayed in conjunction with other
messages that provide information about channel
command word, sense, user ID, and other variables
when necessary.
184 z/VM: System Messages and Codes — CP
System Action: System operation continues.
User Response: None.
HCP531I graf rdev A CONTROL CHECK
OCCURRED
Explanation: The display error recovery routine
detected an irrecoverable error. The addressed device
rdev failed to perform a specified operation or respond
to the control unit within a specified period of time.
This message is displayed in conjunction with other
messages that provide information about channel
command word, sense, user ID, and other variables
when necessary.
System Action: System operation continues.
User Response: None.
HCP532I type rdev AN OPERATION WAS
TERMINATED BECAUSE AN
OPERATION CHECK OCCURRED
Explanation: The type error recovery routine detected
an unrecoverable error. The control unit of the failing
device rdev received a command that is not valid or
order that it cannot execute.
type Type of Error Recovery Routine
GRAF Display device
TAPE Tape
This message is displayed in conjunction with other
messages that provide information about channel
command word, sense, user ID, and other variables
when necessary.
System Action: System operation continues.
User Response: None.
HCP533I type rdev AN UNRECOVERABLE
CHECK DATA ERROR OCCURRED
Explanation: The error recovery routine encountered
an irrecoverable data check during read-back
verification phase of a write command with write and
check data specified in the preceding LOCATE
command.
This message is displayed in conjunction with other
messages that provide information about channel
command word, sense, user ID, and other variables
when necessary.
System Action: System operation continues.
Operator Response: None.