z/VM: System Messages and Codes Š CP - z/VM - IBM

HCP8324E ERROR OCCURRED DURING BUILD
OF FILEPOOL VMSYS
Explanation: An error occurred during the build of the
VMSYS filepool.
System Action: Processing stops.
User Response: Contact IBM Support for assistance.
HCP8327W SEGMENT NAME segname ENTERED
FOR SEGMENT segname is ALREADY
IN USE
Explanation: The segment name selected is already
in use.
System Action: The panel is redisplayed.
User Response: Change the segment name to a
unique name.
HCP8330E DEVICE ADDRESS MUST BE
BETWEEN addr1 AND addr2
Explanation: You entered a device address that was
not in the specified range of valid addresses.
System Action: The panel is redisplayed.
User Response: Enter valid address(es).
HCP8338I NOW EXECUTING stepname STEP
Explanation: The EXEC is executing the named step.
System Action: None.
User Response: None.
HCP8339I BYPASSING stepname DUE TO
condition
Explanation: The step named was executed by a
previous iteration of the EXEC.
System Action: The step is bypassed.
User Response: None.
HCP8340E command FUNCTION HAS FAILED
WITH RETURN CODE rc. PLEASE
CORRECT THE PROBLEM AND
RE-RUN command. ERRORS HAVE
BEEN LOGGED IN log ON 2CC DISK
Explanation: The FUNCTION named failed with the
return code stated.
System Action: Processing stops.
User Response: Contact IBM Support for assistance.
Errors are logged in the message log on the 2CC disk.
HCP8341I command FUNCTION HAS COMPLETED
SUCCESSFULLY
Explanation: The command completed without errors.
System Action: None.
User Response: None.
HCP8342E THE COMMAND command FAILED
WITH RC=rc
Explanation: The COMMAND named failed with the
return code stated.
System Action: Processing ends.
User Response: Contact IBM Support for assistance.
HCP8343W THE COMMAND command COMPLETED
WITH RC=rc. PROCESSING
CONTINUES
Explanation: The COMMAND completed with the
return code stated.
System Action: Processing continues.
User Response: None.
HCP8344I command COMMAND FAILED FOR
packaddr - REISSUING COMMAND.
Explanation: An error occurred during the execution
of the specified command. The system reissues the
command to see if it works the second time.
System Action: Processing continues.
Operator Response: None.
HCP8345E RESTART RECORD fn ft fm EXISTS.
PLEASE ISSUE command (RESTART
TO CONTINUE.
Explanation: You entered an Install command that
failed. If this message is displayed, it means that you
can issue the command with the RESTART option and
the command will pick up where the error occurred.
System Action: Processing stops.
Operator Response: Issue the command with the
(RESTART option.
HCP8346E RESTART RECORD fn ft fm DOES NOT
EXIST BUT THE RESTART OPTION
WAS SPECIFIED.
Explanation: You specified the RESTART option when
no restart record exists.
System Action: None.
HCP8324E HCP8346E
Operator Response: Issue the command without the
(RESTART option.
Chapter 3. System Messages 441