z/VM: System Messages and Codes Š CP - z/VM - IBM

HCQ025E HCQ033E
User Response: Exit from CMS Subset and enter the
VMDUMPTL command again.
HCQ025E Error reading storage at address
Explanation: An error was returned from the SETVAR
subcommand indicating that the requested storage
address could not be read. There was either a problem
reading the actual dump file, or the page was not
included in the dump.
System Action: The subcommand terminates.
User Response: Correct the address and enter the
macro again.
HCQ026E Hex string not an even number of
digits
Explanation: The hex string input to the subcommand
or macro must consist of an even number of
hexadecimal digits.
System Action: The subcommand or macro
terminates.
User Response: Enter the subcommand again using
an even number of digits in the search string.
HCQ027E value1 must be larger than value2
Explanation: The values must be in ascending order.
An ending value was found that was larger than the
starting value.
System Action: The subcommand or macro
terminates.
User Response: Enter the subcommand or macro
again with the correct sequence of addresses.
HCQ028E xxxxxxxx too long - yyyyyyyy
Explanation: The indicated term is longer than
allowed for its meaning in the parameter list. If the term
is a storage address, the subcommand may not support
long addresses.
System Action: The subcommand or macro
terminates.
User Response: Enter the subcommand or macro
again with a shorter address.
HCQ029E No successful locate to resume
Explanation: LOCATE with no parameters can be
issued only to continue a previous LOCATE. In this
case, no previous LOCATE has been issued.
System Action: The subcommand or macro
terminates.
User Response: Enter a LOCATE with parameters,
then a LOCATE with no parameters can be used.
474 z/VM: System Messages and Codes — CP
HCQ030E Error xx writing file yyyyyyyy
Explanation: An error was encountered when writing
the indicated file to disk. One source of the problem is if
the actions of this subcommand or macro cause a
minidisk to fill up.
System Action: The subcommand or macro
terminates.
User Response: Determine the cause of the error, or
get more disk space and enter the subcommand again.
HCQ031E control block not found in dump
Explanation: The control block could not be found.
For the MAP subcommand, modules that reside in free
space in the low Dynamic Paging Area in releases prior
to Version 5 Release 1.0 can be found only via SYSCM;
therefore, information about them will not be available to
the MAP subcommand if SYSCM is not available.
For other commands, the indicated control block is
required but can not be found.
System Action: Processing terminates.
User Response: Be sure the dump is complete or
obtain the desired information another way.
HCQ032E You must specify ALL, a user ID, a
system service name, or the address
of an IUCVBK, CCTBK, or VMDBK
Explanation: The input address was not one of the
items in the list.
System Action: The subcommand or macro
terminates.
User Response: Enter the subcommand or macro
again using one of the items in the list. If you do not
know the name of the specific system service that you
want, use *ALL. If you specified a control block address,
check that it is the starting address of the right type of
control block.
HCQ033E Fatal VMDUMPTL internal error in
pgmname
Explanation: An internal error has been found. This is
an error in the linkage between sections of the VM
Dump Tool program itself, and not from faulty input
parameters.
System Action: The subcommand or macro
terminates.
User Response: Report the problem to the IBM
Support Center.