z/VM: System Messages and Codes Š CP - z/VM - IBM

HCQ087E Overflow
Explanation: The output of the HEX subcommand is
too large to fit into 32 bits.
System Action: The operation terminates.
User Response: Ensure the input values are correct.
Use smaller values.
HCQ088E Not within a module - address
Explanation: The address given to the MAP
subcommand could not be associated with any CP
module in the dump.
System Action: The operation terminates.
User Response: Be sure the address is correct and
retry the subcommand.
HCQ089E High order part of fieldname not zero -
yyyyyyyy
Explanation: This probably indicates an error in either
the requested subcommand or macro or in the CP
tables in the dump used for address translation. The
high order part of the field indicated by fieldname was
not zero. The contents of the byte are indicated by yy.
This condition was not anticipated and is not
meaningful.
System Action: The subcommand or macro
terminates.
User Response: Be sure the requested address is
correct. If the problem persists, contact your IBM
Support Center.
HCQ090I No fields found which match this
criteria
Explanation: This is issued when the BLOCK macro
is invoked with specific displacements, and no fields
were found in this block which reference any of the
displacements specified.
System Action: The subcommand or macro
terminates.
User Response: Be sure the requested displacement
is correct. To produce a list of all of the fields in a
particular control block, invoke the BLOCK macro
without the FIELDS option.
HCQ091E Not a user ID - xxxxxxxx
Explanation: The requested subcommand or macro
accepts only a user ID as input. The input value
indicated by xxxxxxxx could not be identified as a user
ID.
System Action: The subcommand or macro
terminates.
User Response: Enter the subcommand or macro
again using a correct user ID.
HCQ092E Unrecognized type - type
HCQ087E HCQ096E
Explanation: The indicated input was expected to be
a trace type request, but was not recognized.
System Action: The subcommand or macro
terminates.
User Response: See HELP for the TRACE
subcommand to determine the allowable values of
TYPE, and enter the subcommand or macro again
using a correct TYPE value.
HCQ093E Bad Entry Point name or address -
xxxxxxxx
Explanation: The input was expected to be a module
or entry point name, but such a module or entry point
could not be located in the dump. If the dump is a soft
abend dump, the storage containing this module or
entry point was probably not included in the dump.
System Action: The subcommand or macro
terminates.
User Response: Enter the subcommand or macro
again using a correct module or entry point name.
HCQ094E Address cannot be above FC0 in page
- addr
Explanation: The last X'40' bytes in a trace table page
are linkage, so a starting or ending address above
X'FC0' in a trace table page is not allowed.
System Action: The subcommand or macro
terminates.
User Response: Enter the subcommand or macro
again using a smaller displacement in the trace table
page.
HCQ095E addrtype address cannot be 0
Explanation: A value of zero specified to the TRACE
subcommand as an address is not meaningful and is
not allowed.
System Action: The subcommand or macro
terminates.
User Response: Enter the subcommand or macro
again using a correct address.
HCQ096E Not a valid VMDBK address or userid -
xxxxxxxx
Explanation: The indicated input was expected to be
the address of a VMDBK or the user ID of a logged on
user, but was found to be neither.
Chapter 3. System Messages 481