z/VM: System Messages and Codes Š CP - z/VM - IBM

system storage required exceeds the real or virtual
machine size.
System Action: Loading ends. Under CMS, a return
code of 8028 is returned to the caller. Loading
stand-alone in a real or virtual machine will result in a
disabled wait state (wait-state code = 8028).
If using the Stand-Alone Program Loader and the
system enters a disabled wait state, the registers will
contain the values held at the time the wait state was
entered. Register 13 contains the work page address
and is the highest page available.
User Response: Increase your virtual machine
storage size.
HCP8029E The variations of this message are
explained below.
MESSAGES:
v DUPLICATE ESDID DEFINITION; MISSING 'END'
CARD
v Duplicate ESDID definition; missing 'END' card
Explanation: An object file was loaded that did not
have an END card.
System Action: Loading continues, but execution is
attempted.
User Response: A severe error in a reassembly has
probably resulted in a partial object file. Inspect the
indicated object file and reassemble with sufficient
read/write DASD file area.
HCP8030E NO OBJECT FILE FOUND FOR filename
Explanation: No object file for this module was found
on the accessed disks.
System Action: No object file for this module is
loaded. The command runs using the next file in the
load list.
User Response: One or more of the following may be
necessary before reentering the command:
v Access the proper disks.
v Specify the correct file type in the load list or in the
command line.
v Specify the correct control file.
v Specify the correct load list
v Delete the extraneous file name from the load list.
v Specify the correct file name in the load list.
HCP8031W PROGRAM INTERRUPT DURING
LOADING OPERATION
Explanation: An error occurred within HCPLDR while
loading.
System Action: Loading ends. The system enters a
disabled wait state (wait-state code = 8031).
HCP8029E HCP8036E
User Response: Check for any object files assembled
with non-IBM assemblers. If there are no such files,
notify your IBM Support Center personnel immediately.
HCP8032W ATTEMPT TO LOAD FAULTY STORAGE
Explanation: The storage area being loaded is known
to be prone to make errors, correctable or otherwise.
System Action: Loading ends. The system enters a
disabled wait state (wait-state code = 8032).
User Response: Commands exist for reconfiguration
of storage using the MSSF to ensure usable storage.
Your IBM representative can assist you.
HCP8033E NO LOAD LIST SPECIFIED
Explanation: The loader command input did not
identify the exec file containing the names of the object
files to be loaded.
System Action: The command does not run; system
operation continues.
Operator Response: Specify or create the desired file
and reenter the command.
HCP8034E NO CONTROL FILE SPECIFIED
Explanation: The loader command input did not
specify the control file containing the types of object
files to be loaded.
System Action: The command does not run; system
operation continues.
Operator Response: Specify or create the desired file
and reenter the command.
HCP8035E DUPLICATE FILETYPE SPECIFIED -
filetype
Explanation: The indicated file type was specified
more than once in the command line.
System Action: The command does not run; system
operation continues.
User Response: Reenter the command, deleting all
duplicate file types.
HCP8036E TOO MANY FILETYPES SPECIFIED
Explanation: More than 16 file types were specified in
the command line.
System Action: The command does not run; system
operation continues.
User Response: Reenter the command, specifying no
more than 16 file types.
Chapter 3. System Messages 425