z/VM: System Messages and Codes Š CP - z/VM - IBM

HCP2309I LIBRARY libnum IS IN PAUSE MODE
BECAUSE OF A LIBRARY EQUIPMENT
CHECK
Explanation: The library manager has detected an
unrecoverable error, which caused the library manager
to automatically enter the pause state.
System Action: The system logs a permanent error
and continues operation.
Operator Response: Try operating the library
manager manually. If the problem persists, contact your
system support personnel.
HCP2310I LIBRARY libnum REQUIRES
OPERATOR INTERVENTION
Explanation: A cartridge has become inaccessible to
the library, and needs to be retrieved.
System Action: The system logs a temporary error
and continues operation.
Operator Response: Put the library manager into
pause mode and perform the intervention indicated on
the library manager console.
HCP2311E LIBRARY libnum VOLUME volser IS
INACCESSIBLE
Explanation: The specified volume is in a position that
is inaccessible to the library manager, or a condition in
the library manager results in the volume being
inaccessible.
System Action: The operation is terminated, and the
system logs a permanent error.
Operator Response: Put the library manager into
pause mode, place the required volume where the
library manager can access it, and rerun the job.
HCP2312I LIBRARY libnum ALL CELLS ARE FULL
Explanation: All available storage cells in the library
have been filled.
System Action: The system logs a temporary error
and continues operation.
Operator Response: Eject volumes from the library to
make cells available.
HCP2313I LIBRARY libnum DUPLICATE VOLUME
volser WAS EJECTED FROM LIBRARY
Explanation: A duplicate VOLSER was found in the
library. The VOLSER that is ejected is the one that is
not at the location indicated by the inventory.
System Action: The system logs a temporary error
and continues operation.
Operator Response: Retrieve the ejected volume
from the output station and determine why it is a
duplicate.
HCP2314I LIBRARY libnum DUPLICATE VOLUME
volser WAS FOUND IN THE INPUT
STATION
Explanation: A duplicate VOLSER was found in the
input station during an insert operation.
System Action: The system logs a temporary error
and continues operation.
Operator Response: Retrieve the volume from the
input station and determine why it is a duplicate.
HCP2315I LIBRARY libnum VOLUME volser HAS
AN UNREADABLE OR INVALID LABEL
AND WAS FOUND IN THE INPUT
STATION
Explanation: During an insert operation, one of the
following conditions occurred:
v A volume was found with an unreadable VOLSER
label.
v A volume was found without a label.
v A volume was found whose VOLSER contained one
or more invalid characters.
System Action: The system logs a temporary error
and continues operation.
Operator Response: Retrieve the volume from the
input station and determine why the VOLSER was
unreadable or invalid.
HCP2316E LIBRARY libnum VOLUME volser HAS
BEEN MANUALLY EJECTED
Explanation: The volume has been assigned to the
manually ejected category.
System Action: The operation is terminated, and the
system logs a permanent error.
Operator Response: None.
HCP2309I HCP2317I
HCP2317I LIBRARY libnum IS OUT OF CLEANER
VOLUMES
Explanation: A drive cleaning operation was
attempted, but there are no cleaner volumes in the
library.
System Action: System operation continues.
Operator Response: Add cleaner volumes to the
library through the input station.
Chapter 3. System Messages 283