z/VM: System Messages and Codes Š CP - z/VM - IBM

HCP6152E HCP6157E
ALEN translation exception
(X'0029')
ALE sequence exception
(X'002A')
ASTE validity exception
(X'002B')
ASTE sequence exception
(X'002C')
System Action: The command does not run; system
operation continues.
User Response: If the problem occurred during
translation of an address, verify that the address is valid
and try displaying that piece of storage directly. If
unable to display the storage, contact a system
programmer. If the problem occurred during translation
of an address space specification to a segment table
designation (STD), verify that your tables are set up
correctly.
HCP6152E The virtual machine whose TOD clock
you want to change may not be in
ESA/XC mode
Explanation: The virtual machine whose TOD clock
you want to change may not be in ESA/XC mode.
System Action: The system continues to run, but the
command the user entered does not process.
User Response: If you wish to use this command,
change the machine mode of the virtual machine whose
TOD clock you want to change and retry the command.
Operator Response: None.
Programmer Response: None.
HCP6153E Extended IEEE Floating-Point facilities
are not installed.
Explanation: The extended IEEE floating-point
facilities are not installed on the processor where the
system is running. Therefore, the requested operand is
not available.
System Action: System operation continues, but the
command the user entered is not processed.
User Response: Do not attempt to use the FPC
operand if your processor does not include IEEE
Floating-Point facilities.
HCP6154E Extended IEEE Floating-Point facilities
are not active.
Explanation: The extended IEEE Floating-Point
facilities are installed on the processor where the
system is running, but are not yet active for the virtual
machine where the command was issued. Therefore,
the requested operand is not available.
352 z/VM: System Messages and Codes — CP
System Action: System operation continues, but the
command the user entered is not processed.
User Response: Enter this command again after the
virtual machine has performed an IEEE floating-point
operation and has thus been enabled to use IEEE
Floating-Point facilities.
HCP6155E Storage is not addressable because of
an invalid PSW.
Explanation: An invalid guest PSW prevented the
logical address from being resolved.
System Action: The command does not run; system
operation continues.
User Response: Validate the PSW and reenter the
command.
HCP6156E {ASIT asit|Address space identifier
spaceid|Access register acc_reg|ALET
alet} does not designate an address
space to which you have the
appropriate access.
Explanation: The ASIT, SPACE ACCESS REGISTER,
or ALET that you specified does not designate an
address space, you don’t have the type of access you
need to perform the current operation on the address
space, or your access to the address space expired
before you could use it.
System Action: The system continues to run, but the
command entered by the user is not processed.
User Response: Verify that you are using a valid
ASIT, SPACE, ACCESS REGISTER, or ALET, then
request the appropriate access from the owner of the
address space.
HCP6157E Storage is no longer addressable
because of an addressing-capability
exception.
Explanation: Your access to the address space
expired while it was being used. The address space
was originally specified in a DISPLAY/DUMP/STORE
command using the ALET or AREG operand, or by
allowing a logical address space default to AREG.
System Action: The system continues to run, but the
command entered by the user is stopped while partially
complete.
User Response: Contact the owner of the address
space to reestablish your access. Clean up the partially
completed command if necessary.