z/VM: System Messages and Codes Š CP - z/VM - IBM

HCP2819E HCP2827E
4. z/VM shutdown processing is occurring.
In the case of a machine loader, this message is issued
when z/VM shutdown processing is occurring at the
time the request is initiated.
System Action: If the CF Service Machine is not
usable, system operation continues. For the request to
load the machine loader, the IPL is terminated and the
user’s virtual machine is reset.
User Response: Issue the RESTART MSGP
command to reload the CF Service Machine. If this
message is encountered repeatedly, contact your
system administrator or the IBM Support Center for
assistance.
Operator Response: Issue the RESTART MSGP CP
command to reload the CF Service Machine. Or log off
the CF Service Machine with the CP FORCE command,
then issue the XAUTOLOG command to restart the CF
Service Machine. If this message occurs repeatedly,
contact your system administrator or the IBM Support
Center for assistance.
Programmer Response: None.
HCP2819E CFLINK must not start and end at
same CF service machine.
Explanation: An attempt was made to couple a
coupling facility virtual machine (CFVM) to itself.
System Action: The link is not created.
User Response: Do not try to couple a CFVM to itself.
HCP2820E You are not coupled to any CF service
machines.
Explanation: QUERY CFLINKS ALL was entered, but
there are no coupled CFs.
System Action: No query information is displayed.
User Response: Correct the command and try again.
HCP2824E No LOADDEV parameters are currently
defined.
Explanation: A Guest IPL was requested from an
FCP-attached device without previously defining
required parameters with the SET LOADDEV command
or LOADDEV directory statement.
System Action: The IPL request is terminated. The
current user’s virtual machine is reset.
User Response: Use the SET LOADDEV command
or LOADDEV directory statement to identify the location
of the program to be loaded. Then reissue the IPL
command.
314 z/VM: System Messages and Codes — CP
|
|
|
|
|
HCP2824I No LOADDEV parameters are currently
defined
Explanation: A QUERY LOADDEV command was
issued before any SET LOADDEV command was
processed. There is no LOADDEV information to
display.
System Action: System operation continues.
User Response: None
HCP2825E SCPDATA format conflicts with
previous input
Explanation: The user attempted to append or overlay
data in a format that was different from that specified in
a previous SET LOADDEV command. For either
parameter, the data must be all hex or all text.
System Action: The command is not executed; no
LOADDEV data is modified.
User Response: Issue the command again using the
indicated format to append or overlay existing data, or
specify the NEW option to clear the existing data and
change to another format.
HCP2826E {SCPDATA|operand} contains invalid
UTF-8 data: data
Explanation: The specified data is not valid UTF-8
encoding. The offending byte string is displayed as
data.
System Action: The command is not executed; no
LOADDEV data is modified. If the error is from a
directory statement, then the statement is skipped.
User Response: Correct the error and issue the
command again.
HCP2827E SCPDATA offset exceeds current
length of data (nnnn)
Explanation: When appending or overlaying data, the
offset cannot be greater than the length of the existing
data. The offset is the starting point in the existing data
where the new data is to be placed. An offset of 0 will
overlay data beginning at the first character. If the data
format is text, the offset value is expressed in number of
characters. For hex data the offset value is in bytes (two
characters per byte).
System Action: The command is not executed; no
LOADDEV data is modified.
User Response: Issue the command again with a
valid offset.