z/VM: System Messages and Codes Š CP - z/VM - IBM

HCP1013E An invalid operand was supplied for
option - operand.
Explanation: You cannot use the specified operand
with the specified option. If an external security
manager (ESM) is installed on your system, you may
receive this message if you are not authorized to issue
the specified option.
System Action: CP does not execute the command;
system operation continues.
User Response: Issue the command again, and
specify the correct operand or the correct option. Or,
contact your system administrator to obtain the proper
authorization.
HCP1014E A required option is {missing.|missing
- option}
Explanation: A required option is missing from the
command line.
System Action: CP does not execute the command;
system operation continues.
User Response: Enter the command again and
specify a valid option.
HCP1015E [XAUTOLOG failed for userid:]
Insufficient storage is available to
satisfy your request.
Explanation: The contiguous storage required to
satisfy a DEFINE STORAGE, IPL, AUTOLOG,
XAUTOLOG, or LOGON request is not currently
available.
This can occur when more than 1023MB of virtual
storage is being requested.
If the command was an asynchronous XAUTOLOG, the
message text indicates which user ID did not get logged
on.
System Action: System operation continues, but the
command request is denied.
Operator Response: When it is necessary to DEFINE
STORAGE, AUTOLOG, XAUTOLOG, or LOGON with
this amount of storage, you can simply wait, then try
again later.
Otherwise, you can DEFINE STORAGE, XAUTOLOG,
or LOGON with a smaller storage request, or have your
system administrator lower the default storage size in
your directory entry.
When IPLing, simply wait and try again later.
HCP1016E Command rejected; CP does not
support System/370 mode virtual
machines.
Explanation: Machine mode 370 is not valid. CP does
not support System/370 mode virtual machines.
System Action: The command is not executed and
the machine mode is not changed.
User Response: Reissue the command specifying a
valid machine mode. To run 370 applications, use the
370 Accommodation Facility; refer to z/VM: CP
Programming Services for more information.
HCP1017I A channel command was rejected
because you do not have MAINTCCW
authorization.
Explanation: A channel command word (MAINTCCW)
has been encountered that requires MAINTCCW
directory authorization. This MAINTCCW, if not used
properly, could compromise system integrity. Therefore,
this MAINTCCW is disallowed for the general user. This
is done by terminating the channel program with a unit
check and providing sense data that indicates a
command reject.
System Action: System operation continues.
User Response: Contact the system administrator to
obtain MAINTCCW authorization.
HCP1018E The variations of this message are
explained below.
MESSAGES:
HCP1013E HCP1018E
v The POWEROFF function requested on the
SHUTDOWN command is not supported on this
processor.
Explanation: You entered the SHUTDOWN
command with the POWEROFF option, but the
system is currently running on a processor that does
not support this function.
System Action: The command is not executed.
System operation continues.
User Response: Enter the command again with the
correct parameters.
v The AFTER_POWEROFF option requested is not
supported on this processor
Explanation: A user entered the SET or QUERY
PROMPT AFTER_POWEROFF command, or the
FEATURES statement in the system configuration file
specified the ENABLE/DISABLE PROMPT
AFTER_POWEROFF option. The processor is not an
ES/9221 that supports the POWEROFF hardware
feature.
System Action: System operation continues.
User Response: The POWEROFF option is only
supported on ES/9221 processors with the
POWEROFF hardware feature running first level and
Chapter 3. System Messages 223