Original Operating Manual - ROPA Fahrzeug

6 Operation
Chapter 6
Operation
16
6.13.4 Safety circuit when switching on the machine drive
The driver's seat is equipped with a position encoder. Because of this, the machine
drive can only be switched on with the yellow button (6) if the driver's seat is centered
and turned forward and if you had an overview of the pickup. The rotatable seat
6 status indicator (1) on the color terminal must display green (display range between
-20%/0%/+20%). In addition, the pile pickup must be raised high enough so that the
height indicator of the pile pickup (3) also shows green. To switch on the machine drive,
only briefly press the yellow button (6).
First, emit a short but clear horn signal to point out to all bystanders that you are
starting the machine drive and that sufficient distance to the machine must be observed
immediately.
M4001911D
3
(4) Indicator for expiration of cooling-off period
M4001910D
3
(4) Indicator for expiration of cooling-off period (5 seconds
remaining)
If the transport vehicles need to be exchanged rapidly, the machine drive can be
switched on again without turning the driver's seat into the green zone. This is possible
as long as the cooling off period has not expired. This period is counted down on the
color terminal starting from the switch-off time of the machine drive.
Recommendation for fuel-saving loading:
Use the X-Y button (16) to select an engine speed speed between 1200 and 1300 rpm.
174
1
1
4
4