Original Operating Manual - ROPA Fahrzeug

7 Maintenance and Care
Chapter 7
Maintenance and Care
7.6.2 Differential gear on front and rear axle
Replacement of the oil is required after the first 50 operating hours, then annually.
Attention! Risk of injury. Immobilize euro-Maus4 before the oil change and shut off
the engine. The machine must be secured against inadvertent starting of the engine. All
maintenance and repair work may only be performed by trained specialist personnel.
Differential gear units (1) on both axles:
Proceed as follows for the oil change:
– Change the oil only with the gear units at operating temperature.
– Place a catch pan of sufficient size underneath.
– Unscrew the oil drain plug (3) of the differential gear (1). It is located at the bottom,
at the lowest position on the axle body.
– Open the oil level inspection plug (2) and wait until the oil has completely drained.
off
– Screw in the oil drain plug (3) again.
– Add oil to the oil filler opening (2) until the oil level reaches the lower edge of the oil
filler opening (2).
– Screw the oil level inspection plug back in again.
Prescribed gear oil: Gear oil API GL 5, SAE 90
Filling capacities: Differential gear of the front axle approx. 22 liters
Differential gear of the rear axle approx. 20 liters
(1) Differential gear
(2) Oil filler opening and
oil level inspection plug
(3) Oil drain plug
1
2
3
Front axle Rear axle
288
2