Original Operating Manual - ROPA Fahrzeug

6 Operation
Chapter 6
Operation
7
6.13.19 Automatic reversing function for all roller drives
You can set the automatic reversing function in the menu "Basic settings" to "ON" or
"OFF" for all roller drives.
8
9
M4001290GB
The automatic reversing function detects blocks on all roller drives of the beet flow.
When the system detects a block, then the automatic reversing function immediately
stops all drives located in front of the blocked drive. Simultaneously, the traction
drive is stopped.
The automatic reversing function now several times reverses the rotating direction
of the blocked drive (at maximum 5 times), until the block is overcome. Then, all
drives – including the traction drive – are automatically switched on again.
If you do not succeed in release the blockage by reversing after five attempts, then
all drives are switched off.
You can manually start additional tries by reversing using the buttons (7), (8) or (9)
on the right joystick. If this is also unsuccessful, then the cause for the block must
be manually removed.
For this purpose, switch off the machine and secure it against inadvertent starting.
Danger! Danger of severe injuries when removing blocks of drives. In any case, before
removing blocks, completely shut down the machine and secure it against starting by
third parties. For this purpose, withdraw the ignition key and lock the driver's cab. Secure
the ignition key against access by third parties!
196
M4001300GB
M4001300GB