Original Operating Manual - ROPA Fahrzeug

7 Maintenance and Care
Chapter 7
Maintenance and Care
7.11.1 Removal and fitting of pickup and cleaning roller
The pickup roller and cleaning roller may only be removed together because the pig tails
of the pickup roller reach between the disks of the cleaning roller. The gear oil does NOT
have to be drained for removal.
9
1
4
3
The closure cover (1) of the bearing flange (on the outside of the gear unit) must be
taken off before removal of the pickup roller:
– For this purpose, undo the six hexagon bolts (width across flats 13 mm) (2) on the
closure cover and detach the cover.
– Remove the two securing screws (grub screws) (3) which are located beside the
large hexagon bolt (M20x350) (4).
– Unscrew the hexagon bolt (M20 x 360).
298
1
2
8
7
6