Download - SoftMaker

to the Bullets & Simple numbering property sheet and check the Skip numbering
option.
The selected paragraph’s number is removed, and only its indentation is retained.
The enumeration is continued at the immediately following numbered paragraph.
Ending or removing an enumeration
To end an enumeration of paragraphs or to remove a previously applied enumeration,
proceed as follows:
1. Position the text cursor at the end of the last numbered paragraph and press the
Enter key (¢) to begin a new paragraph.
Or: If you want to remove all numbers from a given group of numbered paragraphs,
select them.
2. Invoke the Format > Bullets and Numbering command.
3. Switch to the Bullets & Simple numbering property sheet.
4. Disable numbering by selecting None in the Type group box.
5. Confirm with OK.
Options
The Bullets & Simple numbering property sheet in the dialog box for the Format
> Bullets and Numbering command gives you access to the following options:
Type
Here you can specify either Numbering or a Bullet for the selected paragraph(s).
Select the Numbering option for numbering. (You can find information
relating to the Bullet option in section “Bulleted lists” beginning on
page 87.)
When you set the Type to None, existing bullets or numbers are removed.
You can always transform a numbered list into a bulleted list simply by changing
the Type to Bullet. Naturally, you can proceed in the opposite direction as
well.
172 Automatic numbering Manual TextMaker