Download - SoftMaker

SmartText
With TextMaker’s SmartText feature, you can have your “favorite” typing
errors corrected automatically and create short-cuts for frequently needed
phrases, for example “sd” for “sales department.”
Setting the language
If you have installed more than one language, you can change the language for the
spell checker, hyphenator and thesaurus whenever required.
To change the language, you have the following two options:
Setting the default language
On the one hand, with Tools > Options you can set the default language. The
spell checker, hyphenator and thesaurus normally use the default language.
Formatting text in another language
On the other hand, with the command Format > Character you can format
any segment of text in another language as needed.
In simple terms: Normally, the whole document is formatted in the default language,
and the spell checker, hyphenator and thesaurus use the default language set
in the Tools > Options dialog. However, if you format a segment of text in another
language, the spell checker, hyphenator and thesaurus refer to that language instead.
For detailed instructions, see the following pages.
Setting the default language
By setting the default language, you specify which language the spell checker,
hyphenator and thesaurus will use by default. So you should set your native language
here.
To do this, proceed as follows:
1. Invoke the Tools > Options command.
2. Switch to the Language property sheet.
298 Language tools Manual TextMaker