Download - SoftMaker

Type
Here you can change the type of numbering used. For example, you can select
letters instead of numerals as markers for successive footnotes. The succession
of footnotes is then represented by A, B, C, ... rather than by 1, 2, 3, ...
Start at
Here you can specify the number with which the enumeration should begin.
The default value is “1”. If you enter “42”, for example, the first footnote will
be numbered “42”, the second “43”, etc.
Mode
Here you can specify whether the footnote numbering should be reset to “1”
e.g. on every page or every chapter:
Continuous numbering: The numbering is never reset. This is the default
setting.
Restart on each page: The numbering is reset to “1” at the beginning of every
page of the document.
Restart on each section: The numbering is reset to “1” at the beginning of
every section. (For more information on sections, see the section “What are
sections?” beginning on page 145.)
Restart on each chapter: The numbering is reset to “1” at the beginning of
every chapter. (For more information on chapters, see the section “Dividing a
document into chapters” beginning on page 110.)
Separator line margins group box
Here you can set the margins for the separator line that is inserted automatically
above the footnote area:
The Top margin determines the minimum spacing between the text and the separator
line, while the Bottom margin determines the spacing from the line to the
footnote texts.
As you increase the Left margin, the separator line starts further to the right; as you
increase the Right margin, the separator line ends earlier.
426 Working with large documents Manual TextMaker