Download - SoftMaker

Resetting text to the default language: To reformat a segment of text in the default
language, select it and assign the Default language to it with the Format > Character
command as described above.
Choosing “no” language: If you format a segment of text as No language, no hyphenation
will be performed on it at all. In addition, the spell checker will skip this
segment.
You will find additional information about this topic in section “Setting the language”
beginning on page 298.
Setting the hyphenation frequency
If desired, you can specify how often the hyphenator should break words – or you
can turn hyphenation off. You can do this separately for each paragraph as follows:
First select the paragraphs of interest, then invoke the command Format > Paragraph,
switch to the Text flow property sheet, and select the desired setting in the
Hyphenation dropdown list.
The following options are available:
Setting
None
Always
Every 2 Lines
Every 3 Lines
Effect
No hyphenation is performed.
Hyphenation is attempted in successive lines without limit. This
is the default setting.
Hyphenation is attempted only in every second line.
Hyphenation is attempted only in every third line.
Thus, with None you turn hyphenation completely off for the selected paragraph.
With Always, on the other hand, you allow hyphenation to be performed whenever
possible on any line of the paragraph.
In some cases, it is not always a good idea to hyphenate at every point possible,
and this is where the other two options come in handy. For example, text that is in
narrow columns could lead to a broken word at the end of almost every line and
consequently, to a reduction of the document’s legibility. Therefore, instead, you
may want to use the Every 2 Lines or Every 3 Lines option to direct TextMaker to
attempt hyphenation only in every second or third line.
Manual TextMaker Paragraph formatting 81