AT Command Reference Guide for EDGE Wireless ... - wless.ru

9.10 AT+CLIR Calling Line Identification
Restriction
Description:
Test Command Synatx: AT+CLIR=
Response:
Read Command Synatx: AT+CLIR
Response:
Chapter 9 – Supplementary Service Commands
The AT+CLIR command refers to the GSM supplementary service CLIR. The settings
made with AT+CLIR=1 or AT+CLIR=2 are used for all outgoing calls until the ME is
switched off or AT+CLIR=0 is used.
+CLIR: (list of supported s)
OK
+CLIR,
OK
ERROR
+CME ERROR:
Write Command Syntax: AT+CLIR=[]
Response:
OK
ERROR
+CME ERROR:
Parameter Descriptions:
Parameter shows the settings for outgoing calls:
0 Presentation indicator is used according to the subscription of the CLIR service
1 CLIR invocation
2 CLIR suppression
Parameter shows the subscriber CLIR service status in the network:
0 CLIR not provisioned
1 CLIR provisioned in permanent mode
2 Unknown (e.g., no network, etc.)
3 CLIR temporary mode presentation restricted
4 CLIR temporary mode presentation allowed
9.11 AT+COLP Connected Line Identification
Presentation
Description:
Test Command Syntax: AT+COLP=
Response:
Read Command Syntax: AT+COLP
Response:
This command refers to the GSM supplementary service COLP that enables a calling
subscriber to get the connected line identity (COL) of the called party after setting up a
mobile originated call. The command enables/disables the presentation of the COL at the
TE. It has no effect on the execution of the supplementary service COLR in the network.
+COLP:(list of supported s)
OK
+COLP: ,
OK
ERROR
+CME ERROR:
Write Command Syntax: AT+COLP=[]
Response:
OK
ERROR
+CME ERROR:
Parameter Descriptions:
0 Disable - suppress unsolicited result codes
1 Enable - display unsolicited result codes
0 COLP not provisioned (no presentation)
1 COLP provisioned
2 Unknown
String type phone number of connected address in format specified by
Type of address octet in integer format; 145 when dialing string includes international access code character “+”;
otherwise, 129.
Unsolicited Result Code:
Call response format: +COLP: ,
Multi-Tech Systems, Inc. AT Commands for EDGE Modems (S000371B) 117