AT Command Reference Guide for EDGE Wireless ... - wless.ru

Chapter 13 – Short Message Service (SMS) Commands
13.26 AT^SSCONF SMS Command Configuration
Description:
AT^SSCONF controls details of some SMS releated commands. Please note that
AT^SSCONF settings are stored volatile; i.e., after restart or reset the default values will
be restored.
Test Command Syntax: AT^SSCONF=
Response:
^SSCONF:list of supported s
OK
Read Command Syntax: AT^SSCONF
Response:
^SSCONF:
OK
Write Command Syntax: AT^SSCONF=
Response:
OK
Parameter Description:
Display recipient address
0 The Multi-Tech wireless modem does not display and . These parameters are used
with the result codes of AT+CMGL, AT^SMGL, AT+CMGR, AT^SMGR and the URC “+CDS”.
Default.
1 Multi-Tech wireless modem displays and .
13.27 AT^SSDA Set SMS Display Availability
Description: This command allows to notify the Multi-Tech wireless modem of its controlling application’s
capability to immediately display incoming SMS on a display.
If the application is able to display incoming short messages, a class 0 message shall be
displayed immediately.
However, if it does not, class 0 messages shall be treated as if no message class is determined
(GSM 03.38[17]).
The effect of this command if =1 is to determine the behavior of parameter of
AT+CNMI:
If multiplex mode is enabled (AT+CMUX) and =1 with =1 is set on any logical
channel, all other channels have to use =0.
Test Command Syntax: AT^SSDA=
Response:
^SSDA:list of supported s
OK
Read Command Syntax: AT^SSDA
The read command returns ME’s current capability setting.
Response:
^SSDA:
OK
Write Command Syntax: AT^SSDA=
Response:
OK
Parameter Description:
Display Availability
0 Application is not able to display incoming short message. Default.
1 Application is able to display incoming short message.
Note:
If the ME operates on different instances (MUX channels 1, 2, 3 or ASC0) avoid different settings
for routing and indicating short messages. For example, if messages shall be routed directly to
one instance of the TE (set with AT+CNMI, AT^SSDA), it is not possible to activate the
presentation of URCs with AT+CMER or AT+CNMI on another instance. Any attempt to activate
settings that conflict with existing settings on another interface, will result in CME ERROR, or
accordingly CMS ERROR.
Multi-Tech Systems, Inc. AT Commands for EDGE Modems (S000371B) 191