AT Command Reference Guide for EDGE Wireless ... - wless.ru

Chapter 2 – Configuration Commands
2.13 AT+CSCS Select TE Character Set
Description:
The AT+CSCS write command informs the TA which character set is used by the
TE. This enables the TA to convert character strings correctly between TE and ME
character sets. See also Section 1.5, Supported character sets.
Note that when the TA-TE interface is set to 8-bit operation and the used TE alphabet is 7-
bit, the highest bit will be set to zero.
Test Command Syntax: AT+CSCS=
Response(s):
+CSCS: (list of supporteds), OK
Read Command Syntax: AT+CSCS
Read Response:
+CSCS:
OK
Write Command Syntax: AT+CSCS=[]
Write Response:
Parameter Description:
“GSM“
“UCS2“
OK
GSM default alphabet (GSM 03.38 subclause 6.2.1). Default.
This setting may cause software flow control problems since the codes used to stop and
resume data flow (XOFF = decimal 19, XON = decimal 17) are interpreted as normal
characters.
16-bit universal multiple-octet coded character set (ISO/IEC10646 [32]); UCS2 character
strings are converted to hexadecimal numbers from 0000 to FFFF; e.g., “004100620063”
equals three 16-bit characters with decimal values 65, 98 and 99, $(AT R97)$
2.14 AT^SCFG Extended Configuration Settings
Description:
AT^SCFG queries and configures various settings of the Multi-Tech wireless modem.
AT^SCFG read command returns a list of all supported parameters and their current
values.
The write command queries a configuration parameter (if no value is entered) or sets its
value(s).
Input of parameter names is always coded in GSM character set; parameter values are
expected to be given as specified via AT+CSCS.
The following error messages may be returned to the AT^SCFG write commands:
• “+CME ERROR: operation temporary not allowed”
Change of parameter value(s) temporarily not allowed.
• “+CME ERROR: invalid index”
Invalid parameter name or value(s).
• “+CME ERROR: invalid characters in text string”
Character set conversion of parameter value(s) failed.
• “+CME ERROR: memory failure”
Could not allocate necessary memory or storing a parameter failed.
• “+CME ERROR: operation not allowed”
Change of parameter value(s) not allowed
• “+CME ERROR: unknown”
Other error
Test Command Syntax: AT^SCFG=
Responses:
^SCFG: “GPRS/ATS0withAttach”, (list of supported S)
^SCFG: “GPRS/AutoAttach”, (list of supported S)
^SCFG: “GPRS/RingOnIncomingData”, (list of supported s)
^SCFG: “MEopMode/Airplane”, (list of supported s)
^SCFG: “MEopMode/Airplane/OnStart”, (list of supported s)
^SCFG: “PowerSaver/Mode9/Timeout”, (list of supported s)
^SCFG: “Radio/Band”, (list of supported s), (list of supported s)
^SCFG: “Radio/OutputPowerReduction”, (list of supported s)
^SCFG: “URC/CallStatus/CIEV”, (list of supported s)
^SCFG: “URC/CallStatus/SLCC”, (list of supported s)
^SCFG: “URC/Datamode/Ringline”, (list of supported s)
^SCFG: “URC/Ringline”, (list of supported s)
^SCFG: “URC/Ringline/ActiveTime”, (list of supported s)
OK
Multi-Tech Systems, Inc. AT Commands for EDGE Modems (S000371B) 29